Back Cover For Wire Arrangement; Stand Installation - LG 32LC50C Owner's Manual

32/37/42LG500H
BACK COVER FOR WIRE
ARRANGEMENT
Connect the cables as necessary.
1
To connect additional equipment, see the
EXTERNAL EQUIPMENT SETUP section.
Secure the power cable with the PLUG IN TYPE
HOLDER for power code and PROTECTIVE
BRACKET/Screw. It will help prevent the power
cable from being removed by accident.
PLUG IN TYPE HOLDER
PROTECTIVE BRACKET
(This feature is not available for all models.)
Install the CABLE MANAGEMENT CLIP as shown.
2
If your TV has the CABLE HOLDER, install it as
shown and bundle the cables.
CABLE MANAGEMENT CLIP
CABLE HOLDER
Put the cables inside the CABLE MANAGEMENT
3
CLIP and snap it closed.
PROTECTION COVER
After removing the stand, install the included p p r r o o t t e e c c t t i i o o n n
c c o o v v e e r r over the hole for the stand.
Press the P P R R O O T T E E C C T T I I O O N N C C O O V V E E R R into the TV until you
hear it click.

STAND INSTALLATION

Carefully place the TV screen side down on a cush-
1
ioned surface to protect the screen from damage.
Assemble the parts of the S S T T A A N N D D B B O O D D Y Y
2
with C C O O V V E E R R B B A A S S E E of the TV.
Assemble the TV as shown.
3
4
x 4
Tighten the stand with the
four screws (provided as
parts of the TV).
or
Tighten the two of these four screws
x 2
x 2
and the two Torx plus star head screws
(provided as parts of the TV) to secure the TV. Tighten
the two Torx plus star head screws with a star head dri-
ver bit (not provided as parts of the TV).
! NOTE
When assembling the desk type stand, make sure
G G
the bolt is fully tightened (If not tightened fully,
the TV can tilt forward after the product installa-
tion). Do not over tighten.
S S T T A A N N D D B B O O D D Y Y
C C O O V V E E R R B B A A S S E E
15