MULTIQUIP CA4HC Whiteman Series Operation Manual page 24

6. Grasp the starter grip (Figure 21) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
Figure 21. Starter Grip
7. If the engine has started, slowly return the choke lever
(Figure 19) to the OPEN position. If the engine has not started
repeat steps 1 through 6.
8. Before the trowel is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose V-belt cover or component.
9. To begin troweling, move the throttle lever (Figure 22) toward
the " FAST " position.
Figure 22. Throttle Lever (Run Position)
PAGE 24 — CA4HC WALK-BEHIND TROWEL— OPERATION MANUAL — REV. #0 (09/29/06)
CA4HC TROWEL — INITIAL START-UP
Stopping The Engine
1. Move the throttle lever to the IDLE or SLOW position (Figure
22) and run the engine for three minutes at low speed.
2. After the engine cools , turn the engine start/stop switch to the
"OFF" position (Figure 23).
Figure 23. Engine ON/OFF Switch (OFF Position)
3. Close the fuel shut- off valve (Figure 24) by moving the fuel
valve lever to the OFF position.
Figure 24. Fuel Valve Lever (OFF Position)