Table of Contents
Advertisement
When unpacking the unit, if you nd damage due to shipping, contact your dealer.
INCOMING WATER SUPPLY
Connect a garden hose to the water inlet of the unit. The water supply must be able to deliver 8 gallons per
minute at a minimum pressure of 5 psi.
See "Speci cations and Features" sheet in this manual.
OUTGOING (HIGH PRESSURE) WATER
To the water outlet tting, connect the high pressure hose, trigger gun, extension and nozzle.
PUMP - OIL
Before operating the pump, check to see that the oil is level with the dot on the sight gauge which is located at the
rear of the pump. The oil level can also be checked using the dipstick which is attached to the oil ller cap. Ensure
that the vent hole in the cap/dipstick is clear of dirt. When oil is required, use #20 or #30 non-detergent heavy
duty oil.
BURNER - FUEL
Fill the burner fuel tank with no. 1 or no. 2 fuel oil
BATTERY
Battery must be installed before starting the engine. (the engine will start without the battery installed, but damage
will occur.)
BURNER START UP INSTRUCTIONS
(In the event that the burner has been replaced)
1.
Set the Thermostat substantially above water temperature of the incoming water supply. (In temperate
regions, this is around 50 degrees Fahrenheit.)
2.
Turn on the burner switch.
3.
As soon as the burner motor starts rotating, bleed (prime) the fuel pump. To do this, attach the clear plastic
hose over the vent plug. Loosen the plug and catch the fuel in an empty container. Tighten the plug when all
the air appears to be eliminated.
4.
If the burner stops during bleeding, wait three to ve minutes for the control Safety Switch to cool, then reset
it manually.
5.
If the burner stops after ame is established, additional venting is probably required. Repeat the bleeding
procedure.
CAUTION - Do not attempt to start the burner when excess fuel has accumulated, or when the furnace or
boiler is full of vapor, or when the combustion chamber is hot.
SETTING UP
3
SERIES
GF
Advertisement
Table of Contents
