CONNECTIONS
CONNECTING THE WIRELESS SUBWOOFER
The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link (connect
wirelessly) automatically when the main unit and subwoofer are turned on. If the Link indicator (
light when the main unit and subwoofer are turned on, please set the ID by following the procedure below.
POWER
1. Plug the power cords of the main unit and
subwoofer into an AC wall outlet.
2. Press the ID SET button on the back of the
subwoofer with a small, pointed object for
5 seconds.
The STANDBY indicator is turned off and the
●
LINK indicator (Blue LED) blinks quickly.
3. While the main unit is powered off (in STANDBY
mode), press and hold the
remote control for 5 seconds.
4. The ID SET message appears on the Soundbar's
display.
5. To finalize the link, turn the main unit's power on
while the subwoofer's Blue LED blinks.
The main unit and the subwoofer should now
●
be linked (connected).
The Link indicator (Blue LED) on the
●
subwoofer should be on.
If the Link indicator is not solid blue, the
●
linking process has failed. Turn off the main
unit and start again from Step 2.
You can enjoy better sound from the wireless
●
subwoofer by selecting a Sound Effect.
(See page 10)
Before moving or installing the product,
●
be sure to turn off the power and
disconnect the power cord.
HW-J550-J551-XU ENG-20150211.indd 14
(Mute) on the
14
If the main unit is powered off, the
●
wireless subwoofer will be in standby
mode and the STANDBY LED on the upper
side will come on after the Link indicator
(Blue LED) blinks for 30 seconds.
If you use a device that uses the same
●
frequency (2.4GHz) as the Soundbar near
the Soundbar, interference may cause
some sound interruption.
The maximum transmission distance of
●
the wireless signal between the main unit
and subwoofer is about 33 ft(10m), but
may vary depending on your operating
environment. If a steel-concrete or metallic
wall is between the main unit and the
wireless subwoofer, the system may not
operate at all, because the wireless signal
cannot penetrate metal.
If the main unit doesn't make a wireless
●
connection, follow steps 1-5 in the left
hand column to re-set the connection
between the main unit and wireless
subwoofer.
The wireless receiving antenna is built into
●
the wireless subwoofer. Keep the unit
away from water and moisture.
For optimal listening performance, make
●
sure that the area around the wireless
subwoofer location is clear of any
obstructions.
) does not
2015/2/12 15:43:49