Table of Contents
Advertisement
B. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
Reciprocating Saw
Hammer
Phillips Screw driver
Tape Measure
Level
Non-Combustible Sealant
Material
C. Inspect Appliance and Components
• Carefully remove the appliance and components from the
packaging.
• The vent system components and decorative doors and
fronts may be shipped in separate packages.
• If packaged separately, the log set and appliance grate
must be installed.
• Report to your dealer any parts damaged in shipment,
particularly the condition of the glass.
• Read all of the instructions before starting the
installation. Follow these instructions carefully during
the installation to ensure maximum safety and benefit.
WARNING! Risk of Fire or Explosion! Damaged parts could
impair safe operation. DO NOT install damaged, incomplete or
substitute components. Keep appliance dry.
Hearth & Home Technologies disclaims any responsibility for, and
the warranty will be voided by, the following actions:
• Installation and use of any damaged appliance or vent system
component.
• Modification of the appliance or vent system.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
Any such action may cause a fire hazard.
WARNING! Risk of Fire, Explosion or Electric Shock!
DO NOT use this appliance if any part has been under
water. Call a qualified service technician to inspect the
appliance and to replace any part of the control system
and/or gas control which has been under water.
6
Gloves
Safety Glasses
Electric Drill & Bits
May also need:
Vent Support Straps
Venting Paint
Harman® • XXV Installation Manual_R23 • 2004 -___ • 08/13
3-90-00684i
Advertisement
Table of Contents
