Quick Start Guide; Place The Battery Into The Generator; Connect A Lamp Head; Start Generator - Profoto Pro-B4 1000 Air User Manual

Quick start guide

711rent.com

Place the battery into the generator

Push the battery all the way into the generator. Ensure that both Battery Locks [21] lock
the battery firmly in place.

connect a lamp head

With Profoto's lamp head connection, heads can be connected and disconnected safely
even if the generator is turned on.
If only one lamp head is used, connect the lamp to Lamp Head Socket A [3]
1. Lift the protection lid of the Lamp Head Socket A [3] or B [8].
2. When connecting the lamp head plug, align the white dots on the plug with the white
dot on the generator panel. Secure by turning the ring on the plug clockwise.

Start generator

1. Press the On/Off Button [5] to turn on the generator.
2. The Ready Lamp [19] will be illuminated when the generator is ready.

change light output and settings

1. Use the Control A [16] and Control B [17] to set the light output on outlet A and B.
2. The Mode Control [13] should normally be set to NORMAL. For short flash duration, set
the control to FREEZE. For symmetric energy levels on both channels, set the control
to MASTER.
3. Set the Model Control [11] to SET TIME. The modeling light setting is shown in the
Displays A [14] and B [15]: CONT for continuously on and the time delay in seconds for
automatic turn off. Use the Control A [16] or B [17] to change the setting.
4. Use the Model Control [11] to select modeling light mode: MAX PROP, MAX or PROP.
Press the Model Buttons [18] to turn on the modeling lights.
5. Use the Ready Control [12] to select BEEP, BUZZ or OFF.
6. Use the Sync Control [10] to select synchronizing or set radio channel. Select OFF if
sync cord is used and SLAVE if IR transmitter is used. If Air radio sync is used, set a
channel on SET and then activate Air radio receiver by selecting RADIO.
Connecting Lamp Head
www.profoto.com
7