Cooling Down - Black & Decker CD700 Manual

FEATURES
4
•
•
2
•
5 •
1
•
1. Nozzle
2. On/off heat setting switch
3. Air inlet holes
4. Stands
5. Hanging ring
HANDLING YOUR HEATGUN
CD700 KX1600-1683 UK p01-16
1
•
3
•
• 4
•
3
•
2
• 5
Do not place your
hand over the air
vents or block
these vents in any
way. This restricts
the airflow through
the element and
causes over heat-
ing. Your heatgun
is designed for
one-handed use.
7
OPERATING YOUR HEATGUN
2 or 3 position (position 3 is on KX1683 only). The position
numbers represent the heat numbers described in the table
above. To switch your heatgun off, pull the orange switch
back to reveal the off (O) position.
Note: Allow the element to heat up for a few seconds
before use. Initially, some smoke may emit from your
heatgun. This is normal and will soon cease.

COOLING DOWN

In use, the nozzle of your heatgun becomes extremely
hot. Great care is necessary when cooling your
heatgun after use.
KX1682, KX1683 only:
To speed up the cooling time, set the orange switch to
heat setting 1 for a few minutes before switching your
heatgun off.
cool for at least 30 minutes.
KX1682, KX1683 only:
A rollover feature prevents your heatgun being placed
nozzle down, thus preventing damage to the surface on
which your heatgun is placed.
HANDS FREE USE
Your heatgun is also designed for operation while
placed on the stands (4). Always point your heatgun
15/3/00, 5:31 pm
ENGLISH
KX1682, KX1683
only:
To turn your
heatgun on, push
the orange switch
(2) forward to the 1,
CD700, KX1600 only:
To switch your
heatgun on, press
the rocker switch
to depress the 'I'
position. To switch
your heatgun off,
press the rocker
switch to depress
the 'O' position.
Only after
switching off,
suspend your
heatgun on the
handing ring (5)
or stand the tool
as in "Hands free
use". Leave to
7