Burner Calibration - Viessmann VITOROND 100 Installation And Service Instructions Manual

Initial Start-Up
(continued)

Burner calibration

Instructions supplied
with Beckett burner
Combustion analysis
This oil burner requires combustion
measurements performed at the final
installation site, using calibrated
combustion equipment, to verify factory
settings, or to be used as a guide in
changing burner settings to suite local
conditions.
Examples of local conditions which
influence combustion results include:
weather conditions, length of horizontal
vent pipe, diameter and height of the
chimney, side wall venting (power
vent), altitude above sea level, quality
and heating value of oil used, maximum
number of other fuel burning appliances
running at the same time. These
conditions affect the burner set-up. The
burner must be adjusted for acceptable
combustion results under local
conditions of the installation.
Combustion measurements (CO
temperature, draft and CO) are taken in
the flue pipe between boiler and
barometric draft regulator before
dilution air (see the installation manual).
Overfire draft is measured at the
combustion chamber observation port
opening. The expected CO
range for #2-oil is from 11.0% to
13.0%.
For burner technical data see table on
following page.
Initial Start-up and Service
WARNING
DO NOT USE GASOLINE
CRANKCASE DRAININGS OR ANY
OIL CONTAINING GASOLINE.
WARNING
Always keep the manual fuel supply
valve shut off if the burner is shut
down for an extended period of time.
WARNING
Do not tamper with the unit or
controls.
WARNING
DO NOT START THE BURNER
UNLESS THE COMBUSTION
CHAMBER DOOR IS SECURED IN
PLACE.
, stack
2
WARNING
DO NOT ATTEMPT TO START THE
BURNER WHEN EXCESS OIL HAS
ACCUMULATED, WHEN THE UNIT IS
FULL OF VAPOR, OR WHEN THE
average
COMBUSTION CHAMBER IS VERY
2
HOT.
WARNING
Do not fire boiler without water.
WARNING
Do not leave any tools inside
combustion chamber.
35