Factory Reset; Speaker Configuration - JBL Synthesis SDP-25 Manual

JBL SYNTHESIS SDP-25
SPEAKER SETUP
To assure the best audio performance we recommend the Speaker Settings must be adjusted to
match your system's specific configuration. However, if your installer has already calibrated the
audio levels we strongly recommend that you use those settings without any changes.
Speaker Setup
Speaker Config
Speaker Distance
Speaker Level
DTS – HD Remap

Factory Reset

Back
Note the following regarding the Speaker Setup options:
• The numbers shown for Speaker Configuration will change in accordance with the speakers
set as available in the menu below.
• The DTS-HD Remap options will vary according to the number of speakers in your system
and whether or not there are Height Speakers. Consult the complete Owner's Manual for
more information on DTS-HD Speaker Remap.
• The Factory Reset option returns the Speaker Configuration settings only to their
factory defaults.

Speaker Configuration

Front L/R
Center
Side L/R
Rear L/R
Height L/R
Subwoofer
Back
10
- -
7.1
5
80Hz
80Hz
80Hz
80Hz
None
Yes
The default crossover settings for Speaker configuration are in accordance with industry
standards. If your system has a different number of speakers or if Height speakers are used in
place of Surround Rear speakers, make the adjustments in this menu. If there are no speakers
at any position select "None" and that position will then be grayed out on other Speaker-related
menus.
The next critical setting is for the distance between the speakers and the primary listening
position. This is important to assure a seamless soundfield that has all audio arriving in
synchronization from one channel to the next.
Speaker Distance
Front Left
Center
Front Right
Side Left
Side Right
Rear Left
Rear Right
Height Left
Height Right
Subwoofer
Back
Speaker Setup
120 in
120 in
120 in
120 in
120 in
120 in
120 in
None
None
120 in