Toyota KUN26L-P series Owner's Manual page 43

CANCELING THE IMPACT SENSOR
The impact sensor can be canceled to
prevent false alarms from being triggered
in case of the following conditions:
When parking in the noisy area
D
The vehicle body or glass is subjected
D
to a strong impact from the outside
(such as in highly pressurized car
wash).
When transporting by a car carrier or
D
ferry
26
To cancel the impact sensor:
1. Lock the door by pushing the lock
switch on the wireless remote control
key once, and turn signal lights flash
once.
2. Then, push the lock switch twice within
5 seconds. At this time, the turn signal
lights flash 5 times to indicate the im-
pact sensor function is disabled.
The impact sensor is deactivated as long
as the system remains armed.
CANCELING THE SYSTEM
The system will be canceled by the follow-
ing two ways:
Turn the ignition key from the "LOCK"
D
to "ON" position.
Unlock any of the doors by pushing the
D
unlock switch.
If the turn signal lights flash 3 times, the
system has been alarmed. Check to see
if there is any abnormality with your ve-
hicle.
If any of the doors is not opened within
30 seconds, all the doors will be automati-
cally locked and the system will be set.
WHEN THE SYSTEM IS SET
Activating the system
When the system detects abnormalities
such as follows, it flashes the turn signal
lights and sounds the security horn and
vehicle horn for 30 seconds.
Unlocking any door without using wire-
D
less remote control
Any door or hood is forcibly opened.
D
The battery terminal is disconnected
D
and then reconnected.
The system control assembly is discon-
D
nected and then reconnected.
Abnormal impact is detected when the
D
impact sensor function is on.
Reactivating the alarm
Once set, the system automatically resets
the alarm after the alarm stops.
The alarm will activate again under the
same circumstances described
"Activating the system".
Stopping the alarm
The alarm will be stopped by the following
two ways:
Turn the ignition key from the "LOCK"
D
to "ON" position.
in