Throttle Curve - FUTABA 4PX User Manual

Throttle curve

This function makes the throttle high side and brake side direction servo operation
quicker or milder. It has no effect on the servo maximum operation amount.
For the high side, selection from among three kinds of curves (EXP/VTR/Curve) is also
possible.
Advice
When the course conditions are good and the surface has good grip, set each curve to the +
side (quick side). When the road surface is slippery and the drive wheels do not grip it, set
each curve to the - minus (mild) side.
HOME
screen
Press
Curve selection
First, select the type of forward side curve at the "Type" item. The set-
up item (screen) varies with the type of curve. The figure at the above
is the EXP curve setup screen.
EXP curve screen
Curve type which operates the
throttle from the neutral point
to the high point on a curved
Caution
When Trigger Ratio (p.66) was set to 100:0, brake operation is stopped and the throttle (brake
side) cannot be adjusted.
Dial / Trim Setting
The throttle EXP curve and VTR curve adjustment (Foward side RATE) and(Brake side
RATE) can be controlled with digital trim DT1~DT6 or digital dial DL1 etc. with the func-
tion select dial function. (p.101)
MENU 1 screen
MENU 2
Press
screen
VTR curve screen
Curve type which sets the switching
point between the throttle neutral
point and high point and operates
the throttle on a linear curve.
Throttle curve
(Throttle system)
Press
Press
CRV curve screen
Curve type which sets 9 points
between the throttle neutral point
and high point and operates the
Press
57