SkyLink KN-MT Installation Instructions

INSTALLATION INSTRUCTIONS
Security Keypad
Model: KN-MT
Congratulations on your purchase of the Skylink Security Keypad,
Model: KN-MT. The wireless keypad can arm or disarm your SkylinkNet and
M-Series Alarm system from a secondary location in your home.
Section 1 - Installing the Security Keypad
NOTE: The battery for the Security Keypad is not included. Please refer to
instruction below to insert an AAA Alkaline Battery.
Back
Plate Keypad
AAA Battery
1
1. Undo the screw (1) on the bottom
side of the Keypad (A) and remove
the back plate.
B
Back
Plate
B
3. Mount the back plate with the
4. Attach the Keypad on the back
included screws (B).
plate and tighten the screw (1)
on the bottom of the Keypad.
Safety Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interferences that may cause undesired operation.
WARNING:
Changes or modi cations to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
CE - DECLARATION OF CONFORMITY:
This equipment complies with the requirements relating to electromagnetic
compatibility, EN 301489-1, EN301489-3, EN300220-1, EN300220-2 and
EN60950-1. This equipment conforms to the essential requirement of the
1999/5/EC R&TTE Directive.
Section 2 -
NOTE: You can program in total up to 4 security keychain remotes or keypads
to your M-Series Alarm System.
NOTE: The Security Keypads must be programmed in Zone 1.
1. Press the learn button on the back
of the M-Series Main Console for
3 seconds until the Zone 1 light
is ashing.
2. Insert an AAA Battery.
Back Plate
2. Input Pin followed by the
Disarm button. [Default Pin: 0 0 0 0]
3. Once the keypad is programed to
1
the M-Series Main Console, the
Zone 1 LED light will be off.
Programming the Keypad with M-Series Main Console
LED
Learn Button
Package Contents
Parts
Description
A Security Keypad
B Screw
Section 3 -
Programming the Keypad with SkylinkNet Internet Hub
NOTE: Programming the keypad with the SkylinkNet Internet Hub
must be done from the SkylinkNet App.
1. Go to "More" and tap
on "System Settings".
Disarm
Button
4. Tap on "Security 5. Name your Security
Remote/Keypad". Keypad and tap
"Continue".
A
B
Quantity
1
2
2. Tap on "Setup 3. Tap on "Add Device".
Wizard".
6. Tap on the "Learn Now"
button and input the PIN No.
followed by the Disarm
Button [Default Pin is 0000].