Page 1
HL 670 Data / Impulse Transmitter set User Manual Version 09/2009...
Page 2
1. Global The Set HL670 is ideal for transferring Timing Data and Impulses. Its 500mW emitting power and its licence free frequency range (869 Mhz) makes this device a powerful and simple to use system. Data / Impulse transmission system (500 Mw) which does not require a licence (free of use) in Europe (ISM Band 869 MHz –...
Page 3
1. Functions The Transmitter : IMPULSE Input for timing Impulse (Start gate, photocell – working / closing contact). Respect the polarities. DATA Male Sub-D 9: RS232 input for DATA transfer POWER To switch on the receiver (press for 3 seconds on POWER). The green LED is on. To switch off the receiver, hold down SET and press POWER.
Page 4
The Receiver 1. IMPULSE Output for timing Impulse (Start gate, photocell – working / closing contact). Respect the polarities. 2. DATA Female Sub-D 9 : RS232 Output 3. POWER To switch on the receiver (press for 3 seconds on POWER). The green LED is on. To switch off the receiver, hold down SET and press POWER.
Page 5
HL540-10 or other 12V charger with a minimum of 800 mA. For charging the battery we advise you to use our OEM TAG Heuer charger Using another model may cause some trouble or harm the device.
Page 6
3. System utility : TAG Heuer HL670 Configuration Connect your device with the HL605-10 (delivered with the set) to your computer, run the application. Turn on the system after pressing “Connect”. This application is a free download from our Website : www.tagheuer-timing.com, It...
Page 7
The HL670 will enter in a special setup mode 7. Until the file downloaded then, validate with « OK » For each device, transmitter or receiver, two Software options are available : TAG Heuer Software (TH_Tx_Vxx / TH_Rx_Vxx) This software is especially dedicated for the standard CP540 protocol and the Minitimer.
Page 8
We can reduce this transmission time by increasing the baud rate from the receiver and/or the transmitter. For example, the same frame length with 115200 bps (on both sides) will only take 42ms. Those devices may be used in a “Relay” configuration by plugging directly the Receiver on another Transmitter (through the banana socket or RS232 connection).
Page 9
6. Technical Specification General Impulse response precision: +/- 1/100'000 sec Transmitting delay: 200ms Frequency : 869 MHz REC 70-03 Power 500 mW Autonomy (at +68° F / 20° C) 24 hours (1 Impulse per min.) Impedance : 50 Ohms Antenna 1/4 Wavelength 2.5dBi Impulse Input Short-Circuit / Working contact...
Page 10
Warranty : One year after delivery of your purchase The warranty is null and void under the following conditions: - if the battery is out of order - Poor maintenance and obvious physical damage - Input or Outputs damaged by poor connection - If the device was opened without factory authorization THE INSTALLATION INCLUDES: 1 Plastic case which can store up to 5 Devices...