Custom Function Settings; C.fn I: Exposure - Canon EOS 60D Instruction Manual

Custom Function SettingsN
3

C.Fn I: Exposure

C.Fn I -1
0: 1/3-stop
1: 1/2-stop
Sets 1/2-stop increments for the shutter speed, aperture, exposure
compensation, AEB, flash exposure compensation, etc. Effective when
you prefer to control the exposure in less fine increments than 1/3-stop
increments.
With setting 1, the exposure level will be displayed in the viewfinder and on
the LCD panel as shown below.
C.Fn I -2
0: 1/3-stop
1: 1-stop
C.Fn I -3
0: Off
1: On
For the ISO speed, "H" (equivalent to ISO 12800) will be selectable.
Note that if [8C.Fn II -3: Highlight tone priority] is set to [1: Enable],
"H" (equivalent to ISO 12800) cannot be set.
C.Fn I -4
0: On
The AEB and WB-BKT settings will be canceled if you set the power
switch to <2> or clear the camera settings. AEB will also be
canceled when the flash is ready to fire or if you switch to the movie
mode.
1: Off
The AEB and WB-BKT settings will not be canceled even if you set the
power switch to <2>. (If the flash is ready to fire, AEB will be
canceled temporarily, but the AEB amount will be retained.)
252
Exposure level increments
ISO speed setting increments
ISO expansion
Bracketing auto cancel