Durabrand IB-PH5595 Operating Instructions Manual page 17

DESK USE / WALL MOUNTING (continued)
Wall Mounting without a Modular Wall Phone Plate
Follow these instructions to mount the phone on the
wall without a wall plate:
1. Locate a wall stud. If it is possible to utilize a wall
stud for mounting, dry wall expanders or a similar
type fastener is recommended. Consult your local
hardware stores for details.
2. Drill 2 holes 3 /
15
16
3. Put a screw into each hole and leave
of the head exposed to mount the phone (screws
are not included).
4. Connect the straight cord to the phone and jack.
5. Place the TELEPHONE BASE on the 2 mounting
screws and gently push down to lock into place.
I M P O R TA N T
Before mounting the phone onto the wall, select a wall area with sufficient strength. If mounting
on the wallboard or in an area of questionable strength, locate a stud for maximum support of your
telephone.
Installation on Masonry
1. Use a 1 / 4 " masonry drill bit and drill the 2 holes (spaced as above).
2. Insert plastic anchors and install the 2 screws.
3. Leave 3 / 16 " (5 mm) of the screws exposed to mount the phone.
4. Place the TELEPHONE BASE on the 2 mounting screws and gently push down to lock
into place (anchors and screws are not included).
3 15 / 16 "
(100 MM)
" (100 mm) apart.
DRILL HOLE WITH 1 / 4 " MASONRY BIT
Make sure space
/ " (5mm)
3
16
between holes is
MOUNTING AREA
MOUNTING SCREW
ANCHOR
3 / 16 " (5 MM)
LEAVE 3 / 16 " (5 MM) SCREW EXPOSED
15
Drill one hole
100 mm
Drill other hole
IB-PH5595-WM-E-032704