Aux In Connections - Durabrand pmnHT-4OO Owner's Manual

AUX IN CONNECTIONS

CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8
(OR THE QUICK SETUP DIAGRAM SHEET).
YOUR TAPE RECORDER / PLAYER
•
Illustration is showing some possible connections. You can only connect ONE of these components
to the AUX INPUT jacks of your HOME THEATER SYSTEM (AUX stands for Auxiliary).
•
You can hear the sound of any one of these devices through your HOME THEATER SYSTEM if you
connect the proper cables.
1. Insert the audio cables into the AUX OUTPUT L (left=white) and R (right=red) jacks of your stereo system, such
as a TAPE RECORDER/PLAYER, CD PLAYER into the corresponding AUX INPUT AUDIO jacks on your HOME
THEATER. This will enable you to hear your components system through your HOME THEATER SYSTEM.
NOTE: Your audio device's sound will come out of the 2 front speakers plus the subwoofer since the default
setting for the sound output is the same as the audio source from the device (2 channel, STEREO). For
"Dolby Pro Logic" (5.1 channel) sound reproduction, press the SURROUND button. The sound will
come out of all 5 speakers plus the subwoofer.
NOTE: If the signal of your device (such as a CABLE/SAT BOX or some STEREO TVs) is not a true STEREO
signal, even though it has stereo output jacks, when you press the SURROUND button, the sound
may not come out from all 5 speakers. This is normal.
2. Press the POWER button on the main unit (not the REMOTE) to turn on the main power of the set. Next press the
POWER button on the REMOTE to turn the set on (or off).
3. Press the SOURCE button several times till the AUX indicator lights.
4. Make sure your AUX IN component is on and follow your component 's instructions.
5. Go to Page 20 for detailed instructions.
YOUR CD PLAYER
18
BACK OF HT-400
HOME THEATER
NOTE: Cable requires 3.5mm
stereo plug on one side
of some sets.
IB-HT400-WM-E-042503