Step 7: Adjusting The Burners - Monogram ZGG48N42 Installation Instructions Manual

7
Adjustments should not be required, unless
vibration during transit or variations in local
Step
gas supply make minor adjustments necessary.
Adjustments must be made by a qualified
Adjusting
technician at the time of installation. Extreme
the Burners
care should be used if adjustments are made
after installation.
• Turn gas supply on.
• Push and turn the burner control knobs to
• Flames should be blue and stable with no
TO ADJUST:
• Remove burners by lifting and twisting while
• Locate and loosen the lock screw on the face
• Replace the burners.
• Turn burner knob to the "LITE" position.
• If the flame is yellow, indicating insufficient
Low setting Adjustment:
Minor adjustments may be required due to
fluctuations in local gas pressure. Adjustments
to increase or decrease gas flow may be
necessary.
• Turn burner knob to "LITE" position.
• Turn the control knob to the lowest setting,
• Remove the knob by pulling straight out.
• Insert a thin-blade flat screwdriver into the
• Grip the shaft with pliers and turn the
• When the desired setting is made, replace the
NOTE: Adjustment of the infra-red rotisserie
burner is not recommended.
the "LITE" position. Up to 20 seconds may
be required to to purge air from the lines.
yellow tips, excessive noise or lifting from the
burner. If any of these conditions exist turn
control to off and check air shutter and
burner ports for debris or spider webs.
pulling towards the back.
of the air shutter with a screwdriver.
air, turn the air shutter open to allow more
air to the burner.
all the way counter-clockwise.
valve shaft and hold. (3/32" blade width
recommended.)
screwdriver counter-clockwise to lower the
flame, or clockwise to increase the flame.
knob and turn burner off.
Installation
Outdoor Cooking Centers
1-1/2"
3/8"
• If the flame is noisy and tends to lift away
from the burner, there is too much air. Turn
the air shutter to reduce the opening.
• Side burners can be adjusted in the same
manner.
Bezel
Valve Stem
WARNING:
Always check the low flame size for stability. A
burner flame which is too small may go out or
be extinguished easily. This can cause un-
burned gas to escape and cause a hazardous
condition.
13