Operation - Drill Master 91938 Owner's Manual & Safety Instructions

Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy FROM ACCIDENTAL OpERATION:
Release the Trigger, unplug the tool from its electrical outlet and allow the wheel to cool
completely before performing any inspection, maintenance, or cleaning procedures.
To Remove or Install a Cut-Off Wheel
1. Raise the Saw if it is locked down by pushing
down on it and pulling out the Lock Ball (25).
2. Open the Swing Guard (53) and
tighten the Bolt (112) to secure it
while working on the Wheel.
3. Push the Lock Pin (63) towards the
Fixed Guard (60) as shown in Figure A. Rotate
the wheel until the Lock Pin (63) slides into place.
Lock pin
(63)
Handle
Figure A: Lock pin
Page 8
Fixed
Guard (60)
For technical questions, please call 1-888-866-5797.
4. While continuing to hold down the Lock Pin (63),
use the Hex Key (111a) to loosen the
Socket Head Bolt (54). See Figure B.
Lock
pin (63)
Figure B: Socket Head Bolt
Socket Head
Bolt (54)
Hex Key
(111a)
Item 91938