Identification Information; General Repair Instructions - Toyota Supra 1990 Manual

IN-4
INTRODUCTION - Identification Information, General Repair Instructions
B
A
c
INOOS6
7M-GE
&
7M-GTE Engines
INOOS7
IDENTIFICATION INFORMATION
VEHICLE IDENTIFICATION NUMBER
The vehicle identification number is stamped on the cowl panel.
This number has also been stamped on the vehicle identification
number plate and certification regulation label.
A. Vehicle Identification Number
B. Vehicle Identification Number Plate
C. Certification Regulation Label
ENGINE SERIAL NUMBER
The engine serial number is stamped on the engine block as
showh.
GENERAL REPAIR INSTRUCTIONS
1. Use fender seat and floor covers to keep the vehicle clean
and prevent damage.
2. During disassembly, keep parts in the appropriate order to
facilitate reassembly.
3. Observe the following:
(a) CAUTION: Work must be started after approx. 20
seconds or longer from the time the ignition switch
is turned to the "LOCK" position and the negative
(-) terminal cable is disconnected from the battery
(See page AB-2).
(b) Before performing electrical work, disconnect the
negative from the battery terminal.
(c) If it is necessary to disconnect the battery for inspec-
tion or repair, always disconnect the cable from the
negative (-) terminal which is grounded to the
vehicle body.
(d) To prevent damage to the battery terminal post,
loosen the terminal nut and raise the cable straight
up without twisting or prying it.
(e) Clean the battery terminal posts and cable terminals
with a shop rag. Do not scrape them with a file or
other adrasive object.
(f) Install the cable terminal to the battery post with
the nut loose, and tighten the nut after installation.
Do not use a hammer to tap the terminal onto the
post.
(g) Be sure the cover for the positive
(+)
terminal is
properly in place.