Toshiba RAS-15EKV-UL Service Manual page 62

EXPLOSION HAZARD
WARNING :
Do not install batteries for hard wire installation
Control wire
Remote controller
hanger
Remote controller
Remote controller
"
Screw
Tighten fi rmly but
EXPLOSION HAZARD
WARNING :
not over 0.15 N·m Do not install batteries for hard wire installation
(0.02 kgf·m)
Fig. 10-4-13
*Remark :
1. It is recommended to use double insulation lead wire
to connect remote control to the air conditioner.
2. For hard-wire operation, 1 remote control can control
only 1 indoor unit.
3. In wire operation, (PRESET, TIMER and CLOCK will
return to their initial condition when the user shuts
down the power supply to the air conditioner.
<How to install the air inlet grille on the indoor unit>
• When attaching the air inlet grille, perform the same
process as for removal but in reverse order.
Fig. 10-4-14
10-4-4. Piping and drain hose installation
<Piping and drain hose forming>
Control wire
Screw (∅3.1 x 16L) for
hang remote controller
Wall
Screw (∅3.1 x 25L) for
to battery cover
#
Battery cover
$
INSULATE BOTH LINES
Rear right
Rear left
Bottom left
Left
Bottom right
Right
Right
Rear right
1. Die-cutting front panel slit
With a pair, of nippers, cut out the slit on the leftward or
right side of the front panel for the left or right connection,
and the slit on the bottom left or right side of the front panel
for the bottom left ot right connection.
2. Changing drain hose
For leftward connection, bottom-leftward connection
and rearleftward connection's piping, it is necessary to
change the drain hose and drain cap.
How to remove the drain cap
Clip the drain cap with needle-nose pliers and pull out.
How to remove the drain hose
•
The drain hose can be removed by removing the
screw securing the drain hose and then pulling out
the drain hose.
•
When removing the drain hose, be careful of any
sharp edges the steel plate may have. Sharp edges
can cause injuries.
To install the drain hose, insert the drain hose firmly
•
until the connection part contacts the heat insulator,
and the secure it with the original screws.
Heat insulator
Drain hose
– 62 –
FILE NO. SVM-13070-2
Left
Bottom Rear
right left
Bottom left
Fig. 10-4-15
Fig. 10-4-16
CA