Setting Up The Appliance And Configuring The System; Installing And Setting Up The Appliance; 5620 Back Panel Layout - Symantec 5000 Series Installation Manual

Setting up the appliance and
configuring the system
This chapter includes the following topics:

Installing and setting up the appliance

Shutting down the appliance
Configuring the appliance with the System Setup Wizard
Installing and setting up the appliance
The following instructions describe how to install and set up the Symantec Gateway Security 5600
Series appliance for SGMI management from an internal or external network. You can only configure
one interface for management from the front panel of the appliance. For instructions on configuring
additional interfaces using the System Setup Wizard, see the Symantec Gateway Security 5000 Series
Administration Guide.
If you are configuring an interface for an internal (inside) network, you need to know the following
before you start:
The inside static IP address and subnetmask addresses.
If you are connecting through a VLAN, you need the VLAN identification number. The VLAN
identification number is a digit between 1 and 4094.
If you are configuring an interface for an external (outside) network, you need to know the following
before you start:
The outside static IP address, gateway and subnetmask addresses.
If you are connecting through a VLAN, you need the VLAN identification number.
DHCP is only available when eth1 is configured as an outside interface.
Use the following figures to refer to the back panel features mentioned in these instructions:
See
See
See

5620 back panel layout

Figure 2-1
panel layout is different for all 5600 models.
Figure 2-1, "5620 back panel layout,"
Figure 2-2, "5640 back panel layout,"
Figure 2-3, "5660 back panel layout,"
shows the model 5620 back panel features which are required for the initial setup. The back
Chapter
on page 28.
on page 28.
on page 28.
2