Table of Contents
Advertisement
Table 4: Required Configuration Settings - Master System
Item
Description
Ethernet
IP address
Network address of the AN-30e/AN-50e master system.
IP Subnet Mask
Network subnet mask.
Select the operating mode of the Ethernet port.
Ethernet Mode
Wireless
Master Mode
Set the IDU to operate as the master system. Only one terminal
must be designated master.
-
Note: If this is a PMP system, it is recommended to configure the first link
pair in PTP mode. Operation in PMP mode additionally requires correct
configuration of the system IDs before a link can be established. See the
User manual for correct setup of a PMP system.
RF Freq. [MHz]
Enter the channel center frequency of the system.
Tx Power
Enter the default transmit power level (dBm).
[dBm]
If the Tx power levels are restricted by local regulations, the
maximum Tx power available will be limited to this value.
DFS Action
Select the mode of operation for DFS on this terminal. DFS can not
be disabled where required by regional regulations.
DFS Antenna
Enter the antenna gain (dBm). This value must be set to match the
Gain
system antenna (only if DFS is enabled).
ATPC Enable
Check this box
Adaptive
Check this box
Modulation
Note that adaptive modulation must be disabled after the antenna
is aligned and before TDM lines are put in-service.
Radio Enable
Check this box
Antenna
Check this box
Alignment
(disables voltage output pin).
Encryption
Uncheck this box
Save Settings
Save: Click Save at the bottom of the screen to save the current wireless
configuration settings. All settings will become effective immediately. The saved
settings will be preserved through system reset and power-cycles. If you changed
the AN-30e/AN-50e IP address, you will need to enter the new IP address in the
Web browser to view the Web screens.
70-00042-01-02
BFW
Set mode:
-
AN-30e: Master Mode =
AN-50e: Mode = PTP Master
-
to enable the Automatic Transmit Power Control.
to enable adaptive modulation mode.
to enable the radio transmitter.
to enable the audible antenna alignment
to disable encryption.
Proprietary Redline Communications © 2005
Page 28 of 34
Installation Guide
AN-30e & AN-50e Systems
(enabled)
August 2005
Advertisement
Table of Contents
