Replacing A Pci Adapter - Lenovo 3000 Hardware Replacement Manual

10. Reinstall the front bezel.
11. Go to "Completing the parts replacement" on page 12.

Replacing a PCI adapter

This section provides instructions on how to replace a PCI adapter.
1. Remove the computer cover. See "Removing the cover" on page 7.
2. Remove the screw that secure the adapters.
10
Hardware Replacement Guide
7. Position the replacement memory module over the memory connector. Make
sure that the notch 1 on the memory module aligns correctly with the
connector key 2 on the system board. Push the memory module straight
down into the memory connector until the retaining clips close.
8. Align the drive bay assembly with the two slots and rails on the sides of the
chassis, reconnect the drive cables on the system board, and then slide the
drive bay assembly towards the rear of the chassis until it snaps into position.
9. Reinstall the two screws to secure the drive bay assembly.
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Quick Reference that was included with your computer or in the
Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick
Reference or HMM, go to http://www.lenovo.com/support.