Changing Functions Using The Dip Switches; Operation Panel Dip Switches; Setting The Presser Mode - Brother BE-438C Instruction Manual

12. CHANGING FUNCTIONS USING THE DIP SWITCHES

12-1. Operation panel DIP switches

Switch
DIPA-1
DIPA-2
DIPA-3
DIPA-4
DIPA-5
DIPA-6
DIPA-7
DIPA-8

12-2. Setting the presser mode

Through the combination of DIP switches A-1 and A-2 on the operation panel, presser motions can be set as follows:
DIPA-1 DIPA-2
−
ON
−
ON
Presser does not automatically lift after sewing is
completed.
Two-pedal mode is available.
User program mode is available.
−
The presser does not rise automatically when a split is found.
Displays the enlargement/reduction ratio in millimeter units instead of as a percentage. (After
changing this setting, be sure to carry out the auto-clear operation by referring to page 42.)
Enlargement of pattern size is not available.
Program number is fixed.
Pedal specifications
−
Single pedal
−
Single pedal
ON Two pedals
ON Two pedals
12. CHANGING FUNCTIONS USING THE DIP SWITCHES
The functions shown in the table below can be changed by
means of these DIP switches (1).
* All DIP switches are set to OFF at the time of shipment.
Note:
Always turn off the power before setting the DIP
switches.
2586Q
Motion when set to ON
Raising the presser at the sewing end
Presser is raised automatically.
Presser is raised by pressing the pedal.
Presser is raised automatically, then it is lowered by pressing
the pedal.
Presser is kept lifted while the pedal is pressed.
BE-438C
See "12-2. Setting the presser mode"
0176Q
45