Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bryston D65Z
Summary of Contents for Bryston D65Z
- Page 1 D65Z D130Z D250Z OWNER’S MANUAL...
- Page 2 Bryston authorized dealer to qualify for warranty service. The warranty is transferable from the original owner to a subsequent owner as long as a copy of the bill-of-sale from the original authorized Bryston dealer accompanies the re-sale. The copy of the bill of sale to any subsequent owner need ONLY include the Name of the Bryston Authorized Dealer and the Model and Serial number of the Bryston product The warranty will only be honored in the country of the original purchase unless otherwise pre-authorized by Bryston.
-
Page 3: Table Of Contents
D65Z D130Z D250Z 8 CHANNEL POWER AMPLIFIERS TABLE OF CONTENTS Important Safety Instructions & Warranty ........ opposite General Introduction ..............Page 1 Introduction Description Shipping Box & Packing Materials Installation Wiring the D130/250Z AC Power & Power Conditioners Front Panel .................. - Page 4 Speaker wires should be as short as practical. Use quality wire, and if runs are more than 3 meters use at least 12 gauge wire. The speaker binding posts will accept wire up to 3 gauge in size. Bryston can custom build cables for your application.
-
Page 5: Front Panel
8 CHANNEL POWER AMPLIFIERS FRONT PANEL Although a D130Z is shown above, all front panel features are identical for the D65Z, D130Z & D250Z except for the model name on the power switch POWER SWITCH The front panel label "D65", "D130" or "D250" and the on/off symbol is a switch used to apply or remove A/C line power to the D65/130/250Z soft start circuitry. -
Page 6: Power Inlet
D65Z D130Z D250Z 8 CHANNEL POWER AMPLIFIERS Although a D130Z is shown above, all rear panel features are identical for the D65Z, D130Z & D250Z except for power ratings and fuse values POWER INLET: Primary or mains power cord input connector (IEC 320 C14 inlet, mates with an IEC 320 C13 plug). Connect the supplied power cord to this connector only after checking the unit label and verifying that the amplifier is rated for your local power requirements for A/C voltage and line frequency. -
Page 7: External Zone Mutes
D65Z D130Z D250Z 8 CHANNEL POWER AMPLIFIERS STRIPPED BARE WIRE up to 3 gauge can be inserted through the hole in the binding post and held in place by tightening the post knob. Additional tightening pressure can be achieved using the wrench provided in the slots of the knob. -
Page 8: Technical Specifications
Watts per channel when only 4 channels are driven or 290 Watts per channel when 3 channels are driven. 5: Standby: Unit is plugged in but power switch is deactivated. 300025-3 BRYSTON LTD., 677 NEAL DRIVE, P.O. BOX 2170, PETERBOROUGH, ONTARIO CANADA K9J 7Y4 2011-04-27...