Charred Oak Log Placement - White Mountain Hearth LS-16C-2 Installation Instructions And Owner's Manua

Log set for unvented gas log heater or vented decorative appliance models charred oak charred oak super size

Hide thumbs Also See for LS-16C-2:

Installation instructions and owner's manual (16 pages)

Table Of Contents

Table of Contents

Before you begin: Do not, handle these logs with your bare hands!

Always wear gloves to prevent skin irritation. After handling logs,

wash your hands gently with soap and water.

All Logs

The positioning of the logs is critical to the safe and clean operation

of this heater. Sooting and other problems may result if the logs are

not properly and firmly positioned in the appliance.

refer to figure 1 and figure 1A for the following warning.

warning: Failure to position the parts in accordance with

this diagram or failure to use only parts specifically approved

with this appliance may result in property damage or personal

injury.

PrOPer INSTALLATION SeQueNce:

LS-(18,24,30)c2-1:

(figure 1)

1. Place rear (#1) log onto two (2) pins on rear log support.

2. Place left, front (#2) log onto two (2) left, front pins on burner

pan.

3. Place right, front (#3) log onto two (2) right, front pins on

burner pan.

4. Place Y Branch (#4) onto two (2) pins on rear log.

5. Compare the completed log installation with the appropriate

photo from pages 8 through 10. Review previous steps to make

any necessary adjustments.

6. Log placement is completed.

PrOPer INSTALLATION SeQueNce:

LS-16c-2

(figure 1A)

1. Place rear (#4) log onto right, rear pin on rear log support.

2. Place middle (#1) log between rear log support and burner

pan.

3. Place left, front (#2) log onto two (2) left, front pins on burner

pan.

4. Place right, front (#3) log onto two (2) right, front pins on

burner pan.

5. Compare the completed log installation with the appropriate

photo from page 7. Review previous steps to make any

necessary adjustments.

6. Log placement is complete.

Attention: Do not use Figure 1 or Figure 1A to order replacement

logs. Refer to Page 15 Parts List and Parts View to order logs for

your appropriate model number.

Apply loose material (glowing embers) per appropriate Installation

Instructions and Owner's Manual. Replacement of loose material

(glowing embers) must be purchased from Empire Comfort

Systems, Inc. Application of excess loose material (glowing

embers) may adversely affect performance of the heater.

WARNING: All previously applied loose material must be removed

prior to reapplication.

Page 6