Basic Menu; Detail Menu - Sony RM-B150 Operation Manual

Settings on the RM Configuration Menu

Basic Menu

Category Subcategory Item
Cbl Comp –
Bright
–
Buzzer
–

Detail Menu

Category Subcategory Item
Mode Set –
Gain SW –
SW Setup –
1) Which value may be selected depends on the camera being used.
10 (E)
Setting
Len [10m], 50m, 100m
LED 10 to 99 ([50])
Disp 10 to 99 ([50])
Lvl 0 to 99 ([50])
[On], Off
Out
Setting
Md2, [Md3]
Act
4, [5]
FltMax
–3, [0], 3, 6, 9, 12, 15,
L (RM)
18, . . . , 42
M (RM) –3, 0, 3, 6, [9], 12, 15,
18, . . . , 42
H (RM) –3, 0, 3, 6, 9, 12, 15,
[18], . . . , 42
RM, [CAM]
Mode
AtKnee [AtKnee], KneeSat,
BlkGamma, SkinDtl
Test [1], 2, 3
(A boxed item under "Setting" indicates the factory setting.)
Contents
Sets the cable length for the cable compensation circuit.
Sets the brightness of the LEDs on the control panel.
Sets the brightness of the menu display.
Sets the sound volume of the buzzer.
Turns buzzer output on and off.
(A boxed item under "Setting" indicates the factory setting.)
Contents
Selects the control mode.
Md2: Each time the ACTIVE button is pressed, FULL and
LOCK are toggled.
Md3: Each time the ACTIVE button is pressed, FULL,
PART and LOCK are cyclically switched.
Sets the default nambers of the ND and CC filters.
However, when the connected camera has an automatic
filter detection facility, setting this item is not required.
Selects the gain value for GAIN selector position LOW in
Gain Local mode (in 3 dB steps to 42 dB max.)
Selects the gain value for GAIN selector position MID in
Gain Local mode (in 3 dB steps to 42 dB max.)
Selects the gain value for GAIN selector position HIGH in
Gain Local mode (in 3 dB steps to 42 dB max.)
Selects the Gain Local/Remote mode.
RM: Gain Local mode (The gain is controlled according to
the settings on this unit regardless of the GAIN L/M/H
settings on the camera.)
CAM: Gain Remote mode (The gain is controlled according
to the GAIN L/M/H settings on the camera. Effective only
with a camera equipped with an automatic detection
facility.)
Selects the function of the AUTO KNEE button.
AtKnee: Turns the Auto knee function on and off (on when
lit).
KneeSat: Turns the Knee saturation function on and off (on
when lit).
BlkGamma: Turns the Black gamma function on and off (on
when lit).
SkinDtl: Turns the Skin detail function on and off (on when
lit).
Selects the output signal when the OUTPUT selector is set
to the TEST position.
1: Gamma-waveform signal
2: Three-value staircase signal
3: Ten-value staircase signal
1)
.
1)
.
1)
.