Advertisement
Alternatively, you can hold the
simultaneously. The display will revert to "0" and the
speed alarm will not operate until a new trigger speed is
set.
If the lights are left on when the ignition has been turned off, the Speed Alert alarm will beep
continuously and the LED will flash until the headlights are turned off.
PROBLEM
After calibration of the unit, the display shows 20km/h whenever SET button is
pressed.
SOLUTION
Speed signal missing. Check for correct connection of blue signal wire.
PROBLEM
After ignition is switched off, Speed Alert beeps, and "OO" flashes on display.
SOLUTION
Check that headlights have been switched off, check for correct connection of
white wire. If white wire is not connected, connect it to ground.
PROBLEM
Speed Alert triggers at incorrect speed.
SOLUTION
Speed Alert requires calibration. To do this, depress all three buttons at the
same time for four seconds. The display will now alternate between "CL" and
"60". Drive the vehicle at a steady 60km/h and push the "SET" button. The
speed Alert will now be re-calibrated to your vehicle.
Page 6
TO CANCEL SPEED SETTING
and
buttons
HEADLIGHT WARNING
TROUBLESHOOTING
Advertisement
