Problem Solver - Whirlpool Gas Range User Manual

First t rythesolutions suggested here. Ifyouneed further assistance ormore recommendations thatmay help youavoid aservice c all,
refer t othewarranty page inthismanual andscan thecode there withyour m obile d evice, orvisit
http'//www.whirlpool.com/product help. I nCanada, visithttp'//www.whirlpool.ca.
Contact usbymail w ithany questions orconcerns attheaddress below:
IntheU.S.A.: InCanada:
Whirlpool Brand H ome A ppliances
Customer eXperience Center
553Benson Road
Benton H arbor, MI49022-2692
Please i nclude a daytime phone n umber inyour c orrespondence.
Whirlpool Brand H ome A ppliances
Customer eXperience Centre
200-6750 Century Ave.
Mississauga, Ontario L 5N 0B7
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
PROBLEM POSSIBLE CAUSES AND/OR SOLUTIONS
Nothing will operate
Surface burners will not
operate
Surface burner flames are
uneven, yellow and/or
noisy
Excessive heat around
cookware on cooktop
Cooktop cooking results
not what expected
Power supply cord is unplugged - Plug into a grounded 3 prong outlet.
ENERGY SAVE is active, and the display is blank - Press any key on the control to display the Time of
Day. See the "Electronic Oven Controls" section for more information.
Household fuse is blown or a circuit breaker is tripped - Replace the fuse or reset the circuit breaker.
If the problem continues, call an electrician.
Main or regulator gas shutoff valve is in the off position - See the Installation Instructions.
The range is improperly connected to the gas supply - Contact a trained repair specialist or see
Installation Instructions.
The control knob is not set correctly - Push in knob before turning to a setting.
Air in the gas lines - If this is the first time the surface burners have been used, turn on any one of the
surface burner knobs to release air from the gas lines.
Clogged burner ports - See "Sealed Surface Burners" section.
Clogged burner ports - See "Sealed Surface Burners" section.
Burner caps positioned improperly - See "Sealed Surface Burners" section.
Range converted improperly - If propane gas is being used, contact a service technician or see cover
for contact information.
Cookware and flame are not matched - The cookware should be centered above the burner with the
bottom sitting level on the grate. The flame should be adjusted so that it does not extend up the sides of
the pan.
Improper cookware - Ideal cookware should have a flat bottom, straight sides and a well fitting lid, and
the material should be of a medium to heavy thickness.
Control knob set to incorrect heat level - See "Cooktop Use" section.
Range is not level - Level the range. See the Installation Instructions.
17