i.
Modem module (see
j.
System board (see
Remove the USB/audio board:
1.
Position the computer right-side up, with the front toward you.
2.
Disconnect the cable from the USB/audio board (1).
3.
Remove the Torx T82.5×8.0 screw (2) that secures the USB/audio board to the base enclosure.
4.
Lift the left side of the USB/audio board (3) until the USB and audio connectors disengage from
the openings in the base enclosure.
5.
Remove the USB/audio board and cables from the base enclosure.
Reverse this procedure to install the USB/audio board.
Modem module on page
System board on page
62)
87)
Component replacement procedures
93