Table of Contents
Advertisement
Hardware Installation
)*
!
2.5.1. Floppy Disk Drive Connector
Connector:
CN8 (FDC)
Type:
34 pin block
The FDC connector can support two floppy drives. It is located at the front of
the mainboard. To connect, use the ribbon cable that has been provided. Make
sure that the red strip is connected to Pin 1 of the connector.
Top View of a Floppy
Disk Drive Connector
2.5.2. Primary and Secondary IDE Connectors
Connector:
CN9 (IDE1)/CN10 (IDE2)
Type:
40 pin block
The mainboard has two IDE connectors: a primary and secondary. Each IDE
connector can support two IDE drives. The mainboard each can therefore sup-
port up to four IDE devices. If you install two hard drives, you need to config-
ure the second drive to Slave mode in the BIOS setup. Please refer to your
hard drive manual for the appropriate jumper settings.
Pin 1
2.5.3. Infrared Connector (optional )
Connector:
Type:
The IR connector supports an optional wireless transmitting and receiving
module. Please make sure the Pin 1 location.
Top View of an IR Connector
1
5V DC
2
No Connection
3
IR Reciever
4
Ground
5
IR Transmitter
The KT Mainboard Series
#
+
CN12 (IR)
5 pin
Front View of an IR Connector
IR Receiver
5V DC
+
Top View of an
IDE Connector
Ground
IR Transmitter
Page 15
Advertisement
Table of Contents
