I Nsert L Eveling; Clearances To Combustibles - Lennox Hearth Products Direct-Vent Gas Installation And Operation Manual

Clearances to Combustibles

m C
inimum learanCes to
E = 31-1/2" (800mm) from Top Facing to Bottom of
Insert
F = 25-1/2" (648mm) from Center of Glass to Side Facing
or Side Wall
J = 39" (991mm) from 10.5" (267mm) Mantel to Bottom
of Insert
h p
earth roteCtion
G = Minimum Hearth Protection from Front of Insert*
H = Vertical Distance from Insert Bottom to Combustible
Material.
G 13"(330mm)
H 0"(0mm)
Note: Hearth protection to be min. /8" (10mm) thick non-
combustible or equivalent, with a k factor of .84.
i l
nsert eveling
At each front and rear corner of the insert is an adjustable leg
provided to level the insert should the hearth of the fireplace
be uneven. To adjust the legs, loosen the two 5/32" allen head
screws, move the leg to the desired height, and then tighten
the screws. Repeat these steps for each adjusting leg.
8
C
ombustibles
10"(254mm) 0"(0mm)
2"(21mm) 4"(102mm)
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
f
aCing and
3"/76mm
1-1/2"
38mm
33-1/2"
851mm
31-1/2"
800mm
Figure 4
C
MANTEL
Mantel
TRIM
Trim
E
G
Hearth / Floor Protection
Figure 5
m C
antel learanCes
3"/76mm
3"/76mm
Facing &
Mantel -
Side View
39-1/2"
1003mm
36-1/2"
927mm
learanCes
F
C L
H
J