Superior Network Adapter 206M Installation Instructions

INSTALLATION INSTRUCTIONS FOR OUTSIDE COMBUSTION AIR GATE KIT FOR USE WITH UVF-36,
UVFRC-3628, UVFRC-3628-H, UVFRC-4228 & UVFRC-4228-H UNIVERSAL VENTFREE FIREBOXES
KIT CONTENTS
ITEM QUANTITY DESCRIPTION
1 1 ea. Air Gate Assembly
2 1 ea. Arm, Air Gate
3 1 ea. Bracket, Air Gate Arm
4 1 ea. Collar, Outside Air
5 1 ea. Duct, 4"
6 1 ea. Hardware Kit (9 long screws & 4 short screws)
7 1 ea. Instruction Sheet
Table 1
- Refer to Figure 1
6
1
2
Figure 1 - Kit Contents
(see Table 1)
TOOLS / SUPPLIES REQUIRED
• 5/16" Nut driver or Socket
GENERAL INFORMATION
This kit is for use with models UVF-36, UVFRC-3628, UVFRC-3628-H,
UVFRC-4228 & UVFRC-4228-H Ventfree fi reboxes when installed in con-
ventional construction.
These kits have an air gate assembly which allows adjustment of the amount
of outside air delivered to the fi re for combustion. Only one air kit, located
on the right side of the fi rebox, is required.
If you encounter any problems, need clarifi cation of these instructions or are not
qualifi ed to properly install this kit, contact you local distributor or dealer.
Retain These Instructions for Future Reference
INSTALLATION INSTRUCTIONS
1. Remove the outside air knock-out on the right hand side of appliance
(See Figure 2 for location).
2. Assemble the Air Gate as shown in Figures 3 & 4.
3. Take the Air Gate Assembly and feed the arm
through the round opening (see Figures 5 & 6)
and then through the side frame opening. Ensure
the air gate arm remains attached to the air gate
(see Figure 7).
750,206M
REV. NC 03/2006
5
7
4
3
• Duct Tape • Silicon Type Caulking
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Cat. No. Model
H3991
Do not operate the combustion air gate with a fi re in the fi rebox
unless all components of this kit have been installed.
Right Hand Side
of Firebox
Remove Outside
Air Knock-Out
1
Figure 2
Air Gate
Figure 4
HEARTH PRODUCTS
KITS AND ACCESSORIES
Description
OAK-UVFRC OUTSIDE AIR GATE & DUCT KIT
WARNING
Figure 3
Air Gate Arm
Outside View of
Arm installed
into Air Gate.
When assembled onto appliance, the notch
here must be positioned down as shown.
Air Gate
Air Gate Arm
Right Side
Panel on
Firebox
Side View of Arm
installed into Air
Gate.
Air Gate Assembly
Air Gate Arm
Figure 5
1