Lennox Hearth Products L30 DVF-2 Installation And Operation Manual page 14

INSTALLATION
GAS APPLIANCE FINAL ASSEMBLY
After the appliance has been properly installed and
all gas connections have been made and tested, you
can now install the log set. See Door Assembly on
page 14 for door removal instructions.
INSTALLING LOG SET:
WARNING: If logs are not installed according to
the directions in this manual, flame impingement
and improper combustion could occur and result
in excessive production of carbon monoxide
(CO), a colorless, odorless, toxic gas.
This appliance is equipped with a five-piece log set.
Carefully install the logs into the firebox as shown on
this page. All logs should fit down onto pins and
mounts provided. This will ensure a proper flame and
safe combustion.
1. Carefully place the largest log in the rear of the
firebox as shown in the following illustration.
2. Install the front log as shown in the following illus-
tration.
3. Install the right top twig as shown in the following
illustration.
4. Install the center top twig as shown in the following illustra-
tion.
5. Install the left top twig and embers as shown in the follow-
ing illustration (see Glowing Embers on this page).
Glowing Embers
One package of ember material has been included with this
gas appliance. You will not need to use the entire bag (addi-
tional ember material is provided for your future maintenance
needs).
IMPORTANT: The quantity and placement of the ember
material can affect stove performance therefore it is very
important that it be placed as shown in the picture on
instruction # 5 and shown below.
Proper Placement of Ember Material: Unpackage and divide
the fine ember material (mineral wool) into thumbnail sized
fluffy pieces. Distribute the pieces over the top of the front
burner ports and filling the area in front of and beneath the
forward log and running the full length of the log.
PAGE 14