Schematic Diagrams; Important Safety Notice - Sharp LC-40LE730E Service Manual

LC-40LE730
LC-46LE730
SUPPLEMENT
Description:
VOLTAGE MEASUREMENT CONDITION:
1. The voltages at test points are measured on the stable supply voltage of AC 230V. Signals are fed by a color bar
signal generator for servicing purpose and the above voltages are measured with a 20k ohm/V tester.
INDICATION OF RESISTOR & CAPACITOR:
RESISTOR
1. The unit of resistance "" is omitted.
2. All resistors are ± 5%, unless otherwise noted. (J= ± 5%, F= ± 1%, D= ± 0.5%)
3. All resistors are 1/16W, unless otherwise noted.
4. All resistors are Carbon type, unless otherwise noted.
: Solid
C
: Oxide Film
S
: Metal Coating
N
CAPACITOR
1. All capacitors are μF, unless otherwise noted. (P=pF=μμF).
2. All capacitors are 50V, unless otherwise noted.
3. All capacitors are Ceramic type, unless otherwise noted.
(ML): Mylar
(PF): Polypro Film
CAUTION:
This circuit diagram is original one, therefore there may be a
slight difference from yours.

IMPORTANT SAFETY NOTICE:

PARTS MARKED WITH "
IMPORTANT FOR MAINTAINING THE SAFETY OF
THE SET. BE SURE TO REPLACE THESE PARTS
WITH SPECIFIED ONES FOR MAINTAINING THE
SAFETY AND PERFORMANCE OF THE SET.

SCHEMATIC DIAGRAMS

(K=k=1000 , M=M).
: Cement
W
: Special
T
(TA): Tantalum
(ST): Styrol
" ( ) ARE
4