Table of Contents
Advertisement
g the dryer for the first time
see page 7.
cycle without any laundry
Inspecting
the dryer
nnecting the
mains plug
oading laundry
he programme
1
drying programme ...
2
idual requirements
view,
see page 7.
3
Start/Stop button
nly operate the dryer
th the fluff filter inserted.
Drying
Control panel
Drum
Fluff filter
Air inlet
Condensation container
Drying
Emptying condensation
Empty the container after every use.
1.
Remove the condensation container and hold it
level.
2.
Open the locking cap.
Pour out the condensation.
3.
Check the valve in the condensation container for dirt:
If there are fluff deposits on the valve
water. Also pour some tap water into the empty condensation
container then pour it out again through the valve.
To do this, press the valve in and allow all the water to drain out.
4.
Regularly remove any deposits in the locking cap hole
using a pointed object.
5.
Close the locking cap.
6.
Always push the tank fully back in until it locks in place.
If the Container empty / clean filter/air cooler indicator light
comes on after emptying the container
Cleaning the fluff filter
Clean the fluff filter after every use.
1.
Open the door and pull out the fluff filter.
2.
Remove the fluff (brush your hand over the fluff filter).
If the fluff filter is very dirty or blocked, wash it out with warm water
and dry thoroughly.
3.
Replace the fluff filter.
4.
Remove fluff from door/door area.
Switching off the dryer
Set the programme selector to Off.
Do not leave laundry in the dryer.
Removing the laundry
Your dryer has an automatic anti-crease function. The drum is moved at set intervals for 30 minutes after
the programme has ended. Laundry remains loose and fluffy (for 90 minutes, if additional
Reduced Ironing function is selected - depending on model).
End of programme
as soon as End/Anti-Crease indicator light flashes
Adding or removing laundry
The drying cycle can be interrupted in order to add or remove laundry.
The programme must then be continued or ended.
The drum and the door may be hot!
1. Open the door. The drying process is interrupted.
2. Load or remove laundry and close the door.
3. If required, select a new programme and additional functions.
4. Press the
Start/Stop button.
3
rinse the valve under running
see page 10.
4
Advertisement
Table of Contents
