Westinghouse WHI644BA User Manual page 17

PROBLEM POSSIBLE CAUSE AND REMEDY
The residual heat The cooking zone is not hot because it
indicator does not operated only for a short time.
comes on.
The Automatic Heat • There is still residual heat on the
Up function does cooking zone.
not operate.
• The highest heat setting is set.
The heat setting The Power management is activated.
changes between
two levels.
The sensor fields The cookware is too large or you out it too
become hot. near to the controls.
The Automatic Switch Off operates.
comes on
• No cookware on the cooking zone.
comes on
• Not correct cookware.
• The diameter of the bottom of the
cookware is too small for the cooking zone.
There is an error in the appliance.
and a number
comes on.
There is an error in the appliance, because
comes on
either the cookware boils dry or you've used
incorrect cookware. Overheating protection
for cooking zone operates. The automatic
switch-off operates.
REMEDY
If the cooking zone should be hot, speak to
the service centre.
• Let the cooking zone become
sufficiently cool.
• The highest heat setting has the same
power as the Automatic Heat Up function.
See the section Power management.
Put large cookware on the rear cooking zones
if it is necessary.
Deactivate the appliance and activate it again.
• Put cookware on the cooking zone.
• Use the correct cookware.
• Move cookware to a smaller cooking zone.
Disconnect the appliance from the electrical
supply for some time. Disconnect the fuse
from the electrical system of the house.
Connect again. If comes on again, speak
to the service centre.
Deactivate the appliance. Remove the
hot cookware. After approximately 30
seconds, activate the cooking zone again.
If the cookware was the problem, the error
message goes out of the display, but the
residual heat indicator can stay. Let the
cookware become sufficiently cool and refer
to "Cookware for the induction cooking zone"
to see if your cookware is compatible with
the appliance.
17
TROUBLESHOOTING