Philips 14PV135 Service Manual page 8

Reference Notes in the Table
1. Removal of the Rear Cabinet.
Remove four screws (S-1) and two screws (S-2).
Disconnect connector CN804 and remove the Rear
Cabinet.
Caution !!
Discharge the Anode Lead of the CRT with the CRT
Ground Wire before removing the Anode Cap.
2. Removal of the Power Unit and Tray Chassis Unit.
Discharge the Anode Lead of the CRT with the
CRT Ground before removing the Anode Cap.
Disconnect the following: Anode Cap, CN501,
CN551, CN601, and CRT CBA. Then pull the
Power Unit and Tray Chassis Unit out backward.
3. Removal of the Power Unit.
Disconnect connectors
CN602. Then slide the Power Unit out.
4. Removal of the H.V./Power Supply CBA.
Remove six screws (S-3) and pull up the H.V./
Power Supply CBA.
CN502, CN552, and
S-2
5. Removal of the Top Cover.
Remove five screws (S-4) and CL604, and remove
the Top Cover.
6. Removal of the Bottom Plate.
Remove a screw (S-5). Then slide the Bottom Plate
out front.
7. Removal of the Deck Unit.
Remove seven screws (S-6), screw (S-7) and
screw (S-8). Then, desolder connectors (CN201,
CL401, CL402, CL403) and lift up the Deck Unit.
8. Removal of the Text CBA. [ F,G,I,J,L,M ]
Remove screw (S-9), and disconnect connectors
CN751 and CN752. Then, lift the Text CBA up.
9. Removal of the Main CBA.
Remove four screws (S-10) and pull up the Main
CBA.
10.Removal of the CRT.
Remove four screws (S-11) and pull the CRT back-
ward.
S-1
S-1
1-5-7
[1] REAR CABINET
S-2
Fig. 1
T6450DC