Table of Contents
Advertisement
Connecting an HDMI™ or DVI device
to the HDMI input
The HDMI input on your TV receives digital audio and
uncompressed digital video from an HDMI source device, or
uncompressed digital video from a DVI (Digital Visual
Interface) source device.
This input is designed to accept HDCP (High-Bandwidth
Digital-Content Protection) program material in digital form
from EINCEA-861-D-compliant[
1]
consumer electronic
devices (such as a set-top box or DVD player with HDMI or
DVI output).
The HDMI input can accept and display VGA, 480i (60Hz),
480p (60Hz),
nop
(60Hz), 1080i (60Hz), and 1080p
(24Hz!
60Hz) signal formats. For detailed signal specifications, see
page
n.
Supported Audio format: Linear PCM, sampling rate 32/44.11
48kHz
Note:
To connect
a
PC to the HOMI input, see page 22.
To connect a DVI device, you will need:
one HDMI-to-DVI adapter cable (HDMI type A connector)
per DVI device
For proper operation, the length of an HOMI-to-OVI
adapter cable should not exceed 9.8 ft (3m). The
recommended length is 6.6 ft (2m).
one pair of standard analog audio cables per DVI device
- An HOMI-to-OVI adapter cable transfers video only.
Separate analog audio cables are required (see
illustration).
- See "Setting the HOMI'M audio mode"
(I@"
page 35).
TV lower back panel
l ;
I;}
i: ;;
DIGITAl~
HDMIIN
~
AUDIO OUT
Note:
To ensure that the HOMI or OVI device is reset properly,
it is recommended that you follow these procedures:
• When turning on your electronic components,
turn on the
TV
first,
and then the HOMI or OVI device.
• When turning off your electronic components,
turn off the
HDMI
or
DVI
device first,
and then the TV.
[1] EINCEA-861-D compliance covers the transmission of
uncompressed digital video with high-bandwidth digital content
protection, which is being standardized for reception of high-
definition video signals. Because this is an evolving technology, it
is possible that some devices may not operate properly with the TV.
HDMI, the HDMIIogo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC.
VIDEO
I AUDICk
[O~ ~~t
[@~ ~~
l
R
To connect an HDMI device, you will need:
one HDMI cable (type A connector) per HDMI device
- For proper operation, it is recommended that you use an
HOMI cable with the HOMI Logo (Hcml).
- To display an 1080p/60Hz signal format, you will need
a
Category
2
cable. Conventional HOMI/O VI cable may not
work properly.
- HOMI cable transfers both video and audio. Separate
analog audio cables are not required (see illustration).
- See "Setting the HOMI"O! audio mode"
(I@"
page 35).
TV lower back panel
HOMI device
o
J
lLJ
~5 H~~
c:q
~
~
~, ~2·.~~.
~T(75(;1
DIGITAL
HDMIIN
~.---..
••
AUDIO OUT
_ _ •• _
••
To view the HDMI device video:
Select the HDMI 1, HDMI 2, or HDMI 3 video input source on
the TV.*
*
To select the video input source, press INPUT on the remote control
(~page
24). To program the TV remote control to operate other
devices, see Chapter 3.
I
20
Advertisement
Table of Contents
