Sanyo VPC-S5 Service Manual page 16

CL401 waveform
6-2. LCD VcomDC Adjustment
Adjusting method:
1. Adjust LCD "VCOMDC" so that the amplitude of the CL401
waveform is 4.30 V ± 0.05 Vp-p.
CL401 waveform
3-7. Factory Code Setting
1. Check the "Factory Code" display within the Setting group.
2. For U.S.A., Canada and NTSC general area
If "FC_SANYO_U" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
5.60 V
select "FC_SANYO_U".
± 0.05 Vp-p
3. For Europe and PAL general area
If "FC_SANYO_EX" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_EX".
3-8. Language Setting
1. Click on the "
"Language" display BOX.
2. Select language. (Default is English.)
3. End "DscCal" and remove the camera before turning the
camera power OFF.
Calibration
AWB
Focus
UV Matrix
4.30 V
± 0.05 Vp-p Cal Mode
Cal Data
GND
(CL402)
USB storage
Get
Set
– 16 –
" mark located on the right of the
LCD
Upload
R Bright
Firmware
RGB Offset
Image
Tint
Initialize
OK
EVF VCO
H AFC
LCD Type
OK
VID
Set Serial
PID
Set Rev.
" mark
" mark
B Bright VCOMDC
Gain VCOMPP
Phase
Hall Cal.
Test
Setting
Language
Set
Video Mode
Set
Factory Code