Copyright 2005 All rights Reserved Land Pride provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the preparation of this manual, Land Pride assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein. Land Pride reserves the right to revise and improve its products as it sees fit.
Land Pride Important Safety Information Important Safety Information These are common practices that may or may not be applicable to the products described in this manual. Safety at All Times Thoroughly read and understand the instructions given in this manual before operation. Refer to the “Safety Label”...
Page 4
Use the following maximum speed - tow load weight ratios as a guideline: Land Pride 20 mph when weight is less than or equal to the weight of tractor. 10 mph when weight is double the weight of tractor.
Page 5
Land Pride Important Safety Information These are common practices that may or may not be applicable to the products described in this manual. Practice Safe Maintenance Understand procedure before doing work. Use proper tools and equipment, refer to Operator’s Manual for additional information.
Page 6
20566 20566 Table of Contents by Land Pride. When ordering new components make sure the correct safety labels are included in the request. To order new labels go to your Land Pride dealer. 5. Refer to this section for proper label placement.
Page 7
Land Pride Important Safety Information 20566 20567 20567 10/28/05 Table of Contents 839-933C Warning: General 818-339C Warning: High Pressure 839-932C Caution: Watch your step...
To order a new Operator or Parts Manual contact your authorized dealer. Manuals can also be downloaded, free-of-charge from our website at www.landpride.com or printed by your dealer from the Land Pride Service & Support Center CD-Rom. Terminology: "Right " or "Left" as used in this manual is determined by facing the direction the machine will operate while in use unless otherwise stated.
29. Keep all bolts and nuts tight. Replace any damaged or worn parts such as hydraulic hoses and fittings immediately. Always use Land Pride replacement parts. 30. Perform all maintenance procedures as recommended.
See the appropriate section of this manual on how to convert your valve. If you do not know how your valve is currently set-up, check with your Land Pride dealer. Your backhoe cylinders have been filled with oil at the factory.
CAUTION! If you are going to use a closed center tractor hydraulic system to power your Land Pride Backhoe, A Power Beyond and Closed Center Kit must be purchased from your Land Pride Dealer, then you must carefully follow the directions below.
Tractor Valve To Sump (Male) Oil Reservoir (Backhoe, Loader or Suction Hose To Pump Tractor Sump) Suction Filter (Loader or Backhoe) Power Beyond Independent Hydraulic Systems Figure 1-3 Land Pride Power Beyond Outlet Tractor Loader Valve Pump Inlet Valve Tank Press. Pressure Hose...
Page 13
Land Pride Section 1 Assembly and Set-Up Inlet Valve of Backhoe Valve Return Hose From Backhoe Valve 19389 10/28/05 Table of Contents Suction Filter Oil Reservoir (Backhoe or Tractor Sump) Backhoe Independent Hydraulic Systems Figure 1-4 Tank Press. Pump...
If you wish to use the tractor hydraulic system, consult the dealer of your tractor for a safe and proper method of connecting the Land Pride Backhoe to your tractor. For John Deere Tractors The return hose supplied with your backhoe will not be long enough.
Land Pride Section 1 Assembly and Set-Up Lower Link Hitch Bracket Installation 1. Install right hand (#2) and left hand (#1) lower link hitch brackets with bolts (#3) flat washers (#5) and lock nuts (#4). Assemble hitch pins (#7) to hitch brackets as shown.
flat washer (#6) nut (#4) and jam nut (#5). 3. Install stabilizer links (#10) as shown and insert clevis pins (#9) and secure with linchpins (#7). Stabilizer links can be adjusted at both ends to fit your tractor. Stabilizer Kit Installation Land Pride Figure 1-10 20571 10/28/05...
Land Pride Section 1 Assembly and Set-Up Seat Assembly Refer to Figure 1-11: Assemble the seat as shown with the 3/8” flange nuts. A seat adjustment lever is provided beneath the seat for operator comfort. Bucket Installation Refer to Figure 1-12: 1.
(#9) and slide the ripper tooth (#3) out and store pin (#9) back in it’s previous location. The ripper tooth link (#4) can now be used in place of the bucket link (#1). 20598 Ripper Tooth Assembly Land Pride Figure 1-14 10/28/05...
Land Pride Section 2 Operating Instructions Section 2 Operating Instructions IMPORTANT: When loading or unloading, dipper stick Must be extended to avoid contact with ground. Failure to do so may result in serious damage to backhoe assembly. Refer to Figure 2-1.
After a little experience, you will be able to operate the unit with a smooth, steady motion. STABILIZER STABILIZER DOWN DOWN LEFT STABILIZER STABILIZER Control Levers Figure 2-3 Land Pride DIPPER BUCKET BUCKET RIGHT CURL UNCURL DIPPER 10/28/05...
Land Pride Section 2 Operating Instructions Digging Suggestions CAUTION! Always be sure that the stabilizers maintain contact with the ground during digging operations. Take the time to readjust the stabilizers when necessary during digging. Before you begin digging, extend the stabilizers so that they make a firm contact with the ground.
Keep this angle as you drag the bucket with the dipper stick by gradually uncurling the bucket. Intermittently pull the boom lever at the same time to maintain a level bottom. Level Bottom Figure 2-6 Land Pride 19625 Incorrect Angle 19371 10/28/05...
Table of Contents Repaint parts where paint is worn or scratched to prevent rust. Aerosol touch-up paint is available from your Land Pride dealer. Order Land Pride part # 821-002C for Black. Store backhoe in a clean, dry place. Bucket Tooth Replacement To remove a tooth: 1.
Type of Lubrication: Multipurpose Grease Quantity = As required Bucket Cylinder Base End Type of Lubrication: Multipurpose Grease Quantity = As required Dipper Stick Pivot Type of Lubrication: Multipurpose Grease Quantity = As required Land Pride Intervals at which lubrication is required 10/28/05...
Land Pride Section 3 Maintenance and Lubrication 20567 20566 10/28/05 Table of Contents Dipper Stick Cylinder Base End Type of Lubrication: Multipurpose Grease 20567 Quantity = As required Boom Cylinder Rod End Type of Lubrication: Multipurpose Grease 20567 Quantity = As required...
Stabilizer Cylinder Rod End (Both Sides) Type of Lubrication: Multipurpose Grease Quantity = As required Stabilizer Arms (Both Sides) Type of Lubrication: Multipurpose Grease Quantity = As required Boom Swing Pivot Type of Lubrication: Multipurpose Grease Quantity = As required Land Pride 10/28/05...
Land Pride Section 3 Maintenance and Lubrication 10/28/05 Table of Contents Boom Swing Cylinder Rod End (Both Sides) Type of Lubrication: Multipurpose Grease Quantity = As required Boom Swing Cylinder Base End Type of Lubrication: Multipurpose Grease 20567 Quantity = As required...
Swing Cylinders Dual-Hydraulic swing system At the end of each swing Pins Locked in place, grease zerks at pivot points Transport Lock Safety transport boom flip-over lock Bushings Replaceable, steel at all major pivot points Standard Standard Land Pride BH2585 10/28/05...
Land Pride Section 5 Features and Benefits Section 5 Features and Benefits Features Tractor HP Range 30 - 65 HP Hitch – 3-Point Rigid Hitch Mount with Stabilizing Kit for Maximum digging stability. Skid Loader Mountings Selected Mounting Kits available for added versatility.
Replace worn or damaged O-Rings and back up rings. Inspect for free movement of components, check seat for scratches, nicks or other marks. Replace complete relief if metal parts are damaged. Add oil. Check hose connections. Replace or repair pump. Check for leaks. Replace line. Land Pride 10/28/05...
Page 31
Land Pride Section 6 Troubleshooting Problem Cause Slow operation and poor Engine speed too low. Hydraulic System Defective pump. performance Load too heavy. Faulty main relief valve. Internal valve crack. Suction line filter plugged. Oil too heavy for cold weather use.
3680 2710 ft-lb= foot pounds 1950 4290 3160 mm x pitch = nominal thread diameter in millimeters x thread pitch 2190 4820 3560 Land Pride Bolt Head Identification 10.9 Class 5.8 Class 8.8 Class 10.9 l215 1050 1150 1510 1120...