Selecting 12 Or 24 Hour Time Display - La Crosse Technology WS-9021U Owner's Manual

•
*When the signal is successfully received by the Temperature Station, the
icon will be switched on. (If not successful, the icon will not be shown in LCD)
So the user can easily see whether the last reception was successful (icon
on) or not (icon off). On the other hand, the short blinking of the icon shows
that a reception is currently taking place.
•
If the signal reception is not successful on the first frequency (915MHz) for
45 seconds, the frequency is changed to 920MHz and the learning is tried
another 45 seconds. If still not successful the reception is tried for 45
seconds on 910MHz. This will also be done for re-synchronization.

SELECTING 12 OR 24 HOUR TIME DISPLAY

1. Press and hold the set/ch button for about 5 seconds.
2. "12h" will begin to flash in the TIME section of the LCD
3. Press the min/max/+ button to toggle between "12h" and "24h" time.
Note:
• Selecting 12 hour time will automatically select °F as your temperature unit.
• Selecting 24 hour time will automatically select °C as your temperature unit.
4. Press and release the set/ch button again to enter Time Setting.
9