Programming A New Remote Control; Changing The Remote Control Battery; Locating Your Vehicle - Ford FOCUS ELECTRIC 2015 Owner's Manual

E138618
Note: Your vehicle keys came with a
security label that provides important key
cut information. Keep the label in a safe
place for future reference.
Programming a New Remote
Control
To program an additional remote control
See Security (page 64).
Changing the Remote Control
Battery
The remote control uses one coin-type
three-volt lithium battery CR2032 or
equivalent.
Make sure that you dispose of
old batteries in an
environmentally friendly way.
E107998
Seek advice from your local authority
about recycling old batteries.
1. Remove the key blade from the
transmitter.
E142432
Focus (CDH), enUSA, First Printing
Keys and Remote Controls
2. Twist a thin coin under the tab hidden
behind the key blade head to remove
the battery cover.
E138622
3. Remove the old battery.
4. Insert a new battery with the + facing
downward. Press the battery down to
make sure it is fully in the housing.
5. Reinstall the battery housing cover
onto the transmitter and install the key
blade.
Note: Do not wipe off any grease on the
battery terminals or on the back surface of
the circuit board.
Note: Replacing the battery does not delete
the transmitter from your vehicle. The
transmitter should operate normally.

Locating Your Vehicle

Press the lock button on the key twice
within three seconds. The horn sounds and
the direction indicators flash. We
recommend you use this method to locate
your vehicle, rather than using the panic
alarm.
The horn sounds twice and the direction
indicators do not flash if:
• Locking was not successful.
• Any door or the liftgate is open.
• The hood is open on vehicles with an
anti-theft alarm or remote start.
47