Auxiliary 1 Programming - Sanwa MT-4 Operating Manual

[ [ P ROgRaMMing MEnUS
Turning the Throttle Offset Function 'ON' or 'OFF', Continued....
3) Press the ENTER key, then scroll UP or DOWN to change the Throttle Offset value to
'ON' or 'OFF'.
OFFSET TH OFFSET setting range is OFF to ON. The default setting is OFF.
Although the Throttle Offset value is set to 'ON', the Throttle Offset function will not operate until a Position percentage
value is programmed.
Adjusting the Throttle Offset Position Percentage Value
1) From within the OFFSET menu, scroll DOWN to highlight POSITION 0%. Press the
ENTER key, then scroll UP to shift the throttle servo Neutral position the desired
amount toward the Throttle High Side or scroll DOWN to shift the throttle servo Neutral
position the desired amount toward the Throttle Brake Side.
OFFSET POSITION setting range is H100% to B100%. The default setting is 0%.
When a Position percentage value is programmed and the Throttle Offset function is Active, LED 1 (Blue) will flash rapidly
and OFFS will be displayed on the Top Screen.
Controlling the Throttle Offset Function
1) By assigning the Throttle Offset Position programming function to one of the Trim Switches, Auxiliary Lever or Dial Knob, this
function can be adjusted while driving without accessing the Programming Menu. In addition, the Throttle Offset function can be
Toggled 'OFF' and 'ON' by assigning it to one of the Push-Button Switches. For more information, see the Key Assignments
section on pages 56 ~ 61.
08.aUX1 (aUXiLiaRY 1 PROgRaMMing)
The Auxiliary 1 Programming function allows you to program the five different Auxiliary Programming functions that are controlled
by Auxiliary 1 Channel 3. Use the table below to determine the different functions that are available:
FUNCTION FUNCTION NAME
S_AUX Step Auxiliary
P_AUX Point Auxiliary
4WS Four Wheel Steering Mixing
MOA Motor On Axle Dual Throttle Mixing
A_MIX Auxiliary Mixing
IMPORTANT: Prior to programming an Auxiliary 1 Programming function you must first choose the desired Auxiliary
Programming function in the SYSTEM AUX TYPE menu. Only one Auxiliary 1 Programming function can be Active at any
given time.
STEP (STEP aUXiLiaRY)
The Step Auxiliary function allows you to program the Auxiliary 1 servo to move a defined amount when toggled 'ON' and 'OFF'
using a Push-Button Switch. For example, if you assign Auxiliary 1 to a Push-Button Switch, then program the Step Auxiliary
percentage value to 50%, the Auxiliary 1 servo will travel from the Neutral position to 50% of travel when the Push-Button Switch
is pressed. Press the Push-Button switch a second time and the Auxiliary 1 servo will travel back to the Neutral position. This is
useful to control simple ON/OFF functions, such as a reverse servo for a transmission or a mechanical switch to turn lights 'ON'
and 'OFF', etc.
The Step Auxiliary Position value can be adjusted while you're driving using one of the four Trim Switches, the Rotary Dial
or the Auxiliary Lever. The Step Auxiliary function can be toggled 'OFF' and 'ON' by assigning Auxiliary 1 to one of the two
Push-Button Switches. This allows you to control when the Auxiliary 1 servo travels to the programmed Step Auxiliary position.
FUNCTION DESCRIPTION
Controls Step Values That the Auxiliary Servo Travels
Controls Specific Points That the Auxiliary Servo Travels
Controls Four Wheel Steering Options
Controls Dual Throttle Options
Controls User-Defined Auxiliary 1 Channel 3 Mixing Options
Page 29