Installation Precautions - Kyocera FS-C5100DN Operation Manual

xvi

Installation Precautions

Environment
CAUTION Avoid placing the printer on or in locations which
are unstable or not level. Such locations may cause the
printer to fall. This type of situation presents a danger of
personal injury or damage to the printer.
Avoid locations with humidity or dust and dirt. If dust or dirt
becomes attached to the power plug, clean the plug to avoid
the danger of fire or electrical shock.
Avoid locations near radiators, heaters, or other heat
sources, or locations near flammable items, to avoid the
danger of fire.
To keep the printer cool and facilitate changing of parts and
maintenance, allow access space as shown below. Leave
adequate space, especially around the side cover, to allow
air to be properly ventilated from the printer.
Left: 400 mm
(16 inches)
Other Precautions
Adverse environmental conditions may affect the safe operation and
performance of the printer. Install in an air-conditioned room
(recommended room temperature: around 23 °C, humidity: around 60 %
RH) and avoid the following locations when selecting a site for the printer.
- Avoid locations near a window or with exposure to direct sunlight.
- Avoid locations with vibrations.
- Avoid locations with drastic temperature fluctuations.
- Avoid locations with direct exposure to hot or cold air.
- Avoid poorly ventilated locations.
If the flooring is of a soft material, it may be damaged by the casters when
this product is moved after installation.
Top: 400 mm
(16 inches)
Right: 250 mm Rear: 200 mm
(10 inches) (7-7/8 inches)
Front: 600 mm
(23-5/8 inches)