28HW-53E SERVICE MANUAL SEJB28HW53E00 Issued: 17th Dec 2001 DA-50W CHASSIS / SECAM SYSTEM COLOUR TELEVISION B/G, I L/L’, B/G, D/K MODEL 28HW-53E ES/F/IT/SE In the interests of user safety (required by safety regulations in some countries) the set should restored to its original condition and only parts identical to those specified should be used.
Page 2
28HW-53E SERVICE MANUAL UPDATE LOG SHEET Technical Report No. Application Cause / Solution Part No. Page No. Data /Serial No. Technical Bulletin No. Use this page to keep any special servicing information as Technical Report (Bulletin), Technical Information, etc. If only part number changes are required, just change part number directly the part number in the Parts Listing Section.
28HW-53E IMPORTANT SERVICING NOTES Only qualified service personnel are allowed to carry out maintenance and repair of this receiver. SERVICING OF HIGH VOLTAGE SYSTEM AND CRT It is important that the static charge is removed from the high voltage system when carrying out work on the receiver.
28HW-53E ADJUSTMENT PROCEDURES All adjustments to this chassis, except for focus, are carried out in the service mode. • • • • • SERVICE MODE The service mode is provided to enable the engineer to correctly set up the receiver to the CRT fitted in the set.
Page 6
28HW-53E Note that the receiver should be set to FULL MODE before carrying out any geometry adjustments. This can be achieved by pressing the widescreen mode button on the remote control until FULL MODE appears on the OSD. This can only be done out of the service mode.
Page 7
28HW-53E barrel shape. • When the volume down button is pressed, side pincushion changes from pincushion to barrel shape. • Press the stand-by button on the remote control to store. Corner Symmetry Adjust the Corner Symmetry so that the picture is centred.
Page 8
28HW-53E • When the volume down button is pressed, the vertical size of the picture decreases. • Press the stand-by button on the remote control to store. S Correction Adjust the S Correction so that the picture symmetrical between the top, centre and bottom.
Page 9
5. If another NVM value has to be changed, use the channel down button to select the page or position and repeat as necessary. Note: DO NOT change any NVM data, unless you have been advised to do so by a Sharp representative. If data is incorrectly changed, serious damage may occur to the receiver. Contrast Adjustments Three types of contrast levels can be varied as listed below: •...
28HW-53E DVCO Adjustment (PAL) LED FLASHING CODES Carry out the DVCO Adjustment (PAL) as shown below: This model is not provided with stereo led, so to let “flashing 1. Receive a Phillips pattern signal. codes” for IC failures detection when the TV set does not 2.
28HW-53E DESCRIPTION OF SCHEMATIC DIAGRAM NOTE: SAFETY NOTE: 1. The unit of resistance «ohm»is omitted (K=1000 ohms. M= Megaohm). 1. DISCONNECT THE AC PLUG FROM THE AC 2. All resistors are SMD, 1/16 watt. unless OUTLET BEFORE REPLACING PARTS. otherwise noted.
Page 25
28HW-53E SCHEMATIC DIAGRAM OF CRT SOCKET UNIT (F7273N3, 00 Version)
Page 26
28HW-53E SCHEMATIC DIAGRAM OF MOTHER UNIT (K7240N7, 00 Version) Page 28...
Page 27
28HW-53E SCHEMATIC DIAGRAM OF MOTHER UNIT (K7240N7, 00 Version) Page 29...
Page 28
28HW-53E SCHEMATIC DIAGRAM OF MOTHER UNIT (K7240N7, 00 Version)
Page 29
28HW-53E SCHEMATIC DIAGRAM OF MOTHER UNIT (K7240N7, 00 Version)
Page 30
28HW-53E SCHEMATIC DIAGRAM OF PFC UNIT (F7314N3, 00 Version)
Page 31
28HW-53E SCHEMATIC DIAGRAM OF POWER SWITCH UNIT (F7342N1, 00 Version)
28HW-53E PARTS LISTING REF No. PARTS DESCRIPTION * SN CODE EX CODE Q 0405 VS2SA1037KQ-1 TRT BC807 SMD REPLACEMENT PARTS Q 0406 VS2SA1037KQ-1 TRT BC807 SMD Replacement parts which have special safety characteristics are identified Q 0408 VS2SC2412KQ-1 TRT 2SC2412 ROHM in this manual.
Page 34
28HW-53E REF No. PARTS DESCRIPTION * SN CODE EX CODE REF No. PARTS DESCRIPTION * SN CODE EX CODE D 0510 RH-DX0505BMZZ DIODE 1N4935 L 0318 VP-DF3R3K0000 PEAK COIL 3,3UH 10% D 0515 RH-EX0544BMZZ ZENER DIODE TZMC4V7 TFK SMD L 0350 VP-CF3R3K0000 PEAK COIL 3.3UH 10%...
Page 35
28HW-53E REF No. PARTS DESCRIPTION * SN CODE EX CODE REF No. PARTS DESCRIPTION * SN CODE EX CODE C 0321 VCKYTV1HF104Z CERAM C 100NF 50V 2125SMD C 0431 RC-FZ4334BMNJ POL FILM C 330nF 50V 5% ECQ-V PANASONIC C 0322...
Page 36
28HW-53E REF No. PARTS DESCRIPTION * SN CODE EX CODE REF No. PARTS DESCRIPTION * SN CODE EX CODE C 0720 RC-EZ0258CEZZ ELEC C 100MF 200V C 2407 VCKYTV1EF224Z CERAM C 220NF 25V 2125SMD C 0721 RC-EZ0132BMZZ C UVX1V471MPA1CA NICHICON...
Page 37
28HW-53E REF No. PARTS DESCRIPTION * SN CODE EX CODE REF No. PARTS DESCRIPTION * SN CODE EX CODE R 0356 VRS-TV1JD103J 2125 10KOHM 5% 1/10W SMD R 0504 VRS-TV1JD393J 2125 39KOHM 5% 1/10W SMD R 0357 VRS-TV1JD151J 2125 150 OHM 5% 1/10W SMD...
Page 38
28HW-53E REF No. PARTS DESCRIPTION * SN CODE EX CODE REF No. PARTS DESCRIPTION * SN CODE EX CODE R 0644 VRS-TV1JD221J 2125 220 OHM 5% 1/10W SMD R 0812 VRS-TV1JD222J 2125 2,2KOHM 5% 1/10W SMD R 0646 VRS-TV1JD824J 2125 820KOHM 5% 1/10W SMD...
Page 39
28HW-53E REF No. PARTS DESCRIPTION * SN CODE EX CODE REF No. PARTS DESCRIPTION * SN CODE EX CODE CN 0001 QSOCZ2109BMZZ TWIN SCART HR-DG1311G-0 L 0006 QTIPM0017CEFM CN 0002 QSOCZ2107BMZZ SOCKET SW 0001 QPLGN0341CEZZ PLUG SW 0002 QPLGN0341CEZZ PLUG...
Page 40
28HW-53E REF No. PARTS DESCRIPTION * SN CODE EX CODE REF No. PARTS DESCRIPTION * SN CODE EX CODE R 1803 VRS-TV1JD750J 2125 75 OHM 5% 1/10W SMD IC 1701 RH-IX1801BMZZ IC L6561D ST R 1804 VRS-TV1JD101J 2125 100 OHM 5% 1/10W SMD...
28HW-53E PACKING OF THE SET Pack-ad SPAKX4077BMZZ Wrapper SPAKP2006BMZZ FRONT SPAKC5495BMZZ Carton Box Remote Control Batteries RRMCG1070BMSA UBATU0247AJZZ Operation Manual Set FRONT Carton Box...