Sony EVI-D100 Operating Instructions Manual page 23

English
Owner's Record
The model number and the serial
number are located on the bottom
exterior.
Record these numbers in the spaces
provided below. Refer to these
numbers whenever you call upon the
dealer regarding this product.
Model No.
Serial No.
WARNING
To reduce the risk of fire or
electric shock, do not
expose this apparatus to
rain or moisture.
To avoid electrical shock,
do not open the cabinet.
Refer servicing to qualified
personnel only.
This unit has no power
switch.
When installing the unit, incorporate a
readily accessible disconnect device in
the fixed wiring, or connect the power
cord to socket-outlet which must be
provided near the unit and easily
accessible.
If a fault should occur during
operation of the unit, operate the
disconnect device to switch the power
supply off, or disconnect the power
cord.
IMPORTANT
The nameplate is located on the
bottom.
For customers in the U.S.A.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help.
You are cautioned that any changes or
modifications not expressly approved
in this manual could void your
authority to operate this equipment.
All interface cables used to connect
peripherals must be shielded in order
to comply with the limits for a digital
device pursuant to Subpart B of Part
15 of FCC Rules.
GB
23