Fujitsu SERVIS FW-D1008NP Quick Start Manual

TM
SERVIS IP-KVM
Introduction
- Thank you for purchasing this product. This "Quick Start
Guide" describes the items contained in the packaging,
and explains the initial setup and procedures for basic
operations. Make sure to read this manual when using
the device.
- Read the "Safety Precautions" in the CD-ROM provided
with the device in advance for its correct use. The
"Safety Precautions" includes indications to obviate any
chance of accident or damage to you and people near
you, and your property.
- For details on operations, refer to the Installer/User
Guide provided with the device.
Step 1 Checking the Components
Check that the following items are contained in the
packaging.
- The device
- Power cables
3 pin plug-IEC320 socket (AC100V)...1
IEC320 plug-IEC320 (AC200V)...1
- Serial Cable ... 1
- Flanges ... 2
- Screws for flange ...4
- CD-ROM ...1
Installer/User Guide
FW-Client Software
- Warranty certificate ... 1
* This warranty is valid in Japan.
- License information ... 1
- China RoHS guide ...1
- Quick Start Guide
(Japanese, English) ... 1 each
<Inquiry about our products>
FUJITSU COMPONENT LIMITED Marketing Group
TEL: 81-3-5449-7006
E-mail: promothq@fcl.fujitsu.com URL: http://www.fcl.fujitsu.com/en/
FW-D1008NP Quick Start Guide
Step2 Connecting the Device
1. Connect the device as shown below.
2. When you have connected the device, turn on each
connected server first, and then the device.
Ethernet
Telephone
Network
Power Modem
Source
Remote User
FW-D1008NP
Local Connection
Server
Server
Step3 Setting Up the Network
For the initial settings of the device, set the IP address by a local
operation.
1. The device starts operating 2. Press the [PrintScreen] key
about 1 minute after it is on the local keyboard once,
turned on, and the [Free] tag then the following Main
appears in the monitor for window appears. Click
local connection. [Setup].
3. The following Setup window 4.
appears. Click [Network].
5. When you specify a fixed 6.
IPv4 address, click the
"Static" and the "IPv4" radio
button, enter values in the IP
address, Netmask and
Gateway fields, and click the
[OK] button. (For DHCP,
select the corresponding
Opion.)
Server
Server
Step4 Installing FW-Client
By using the device, install "FW-Client" – a tool for managing the
target device – into the remote client's PC. The following explains
how to install into a Windows computer.
1. Launch Setup.exe, 2.
contained in the CD-ROM
provided with the device.
3. The following dialog box
The following Network
window appears. Specify the appears. Click [Next].
IP address here.
5. The contents of the dialog
The following message
box are shown as below.
appears, and the device
Select the install destination,
restarts. If the [Free] tag is
and click [Next].
shown 1 minute later, the
network setup is complete.
7. The following dialog box
appears. Click [YES].
9. When the contents of the
dialog box are shown as
below, the installation is
complete. Click [Done].
The following dialog box
appears. Click [OK].
4. On the following dialog box, if
you agree with the statement,
select the corresponding option,
and click [Next].
6. The contents of the dialog box
are shown as below. To set an
icon on the desktop, select the
check box and click [Install].
8. The following dialog box is
shown, and installation starts.
(Continued to the reverse side)
NC14013-0922RS-02