Cisco TelePresence SX20 Administrator's Manual page 64

Cisco TelePresence SX20 Quick Set
Contents
Cameras Camera [1] Flip
With Flip mode (vertical flip) you can flip the image upside down. Flipping applies both to the
self-view and the video that is transmitted to the far end.
Requires user role: USER
Value space: <Auto/Off/On>
Auto: If the camera detects that it is mounted upside down, the image is automatically
flipped. If the camera cannot auto-detect whether it is mounted upside down or not, the
image is not changed.
Off: Display the image on screen the normal way.
On: Display the image flipped upside down. This setting is used when a camera is mounted
upside down, but cannot automatically detect which way it is mounted.
Cameras Camera 1 Flip: Auto
Example:
Cameras Camera [1] Focus Mode
Set the camera focus mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the
right focus; then auto focus is turned off to prevent continuous focus adjustments of the
camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Cameras Camera 1 Focus Mode: Auto
Example:
Cameras Camera [1] Gamma Mode
This setting enables gamma corrections, and applies only to cameras which support gamma
mode. Gamma describes the nonlinear relationship between image pixels and monitor
brightness.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref:
Cameras Camera [1..n] Gamma Level.
Cameras Camera 1 Gamma Mode: Auto
Example:
D14908.10 SX20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings
Cameras Camera [1] Gamma Level
By setting the Gamma Level you can select which gamma correction table to use. This setting
may be useful in difficult lighting conditions, where changes to the brightness setting does not
provide satisfactory results. Requires the Gamma Mode to be set to Manual.
Requires user role: ADMIN
Value space: <0..7>
Range: Select a value between 0 and 7.
Cameras Camera 1 Gamma Level: 0
Example:
Cameras Camera [1] IrSensor
A Precision camera has an IR sensor that is used when you operate the codec with a remote
control. The IR sensor is located at the camera front, and the LED flickers when the IR sensor is
activated by the remote control.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the IR sensor of the camera.
On: Enable the IR sensor of the camera.
Cameras Camera 1 IrSensor: On
Example:
Cameras Camera [1] Mirror
With Mirror mode (horizontal flip) you can mirror the image on screen. Mirroring applies both to
the self-view and the video that is transmitted to the far end.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: If the camera detects that it is mounted upside down, the image is automatically
mirrored. If the camera cannot auto-detect whether it is mounted upside down or not, the
image is not changed.
Off: Display the image as other people see you.
On: Display the image as you see yourself in a mirror.
Cameras Camera 1 Mirror: Auto
Example:
www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
64
Administrator Guide
Setting passwords Appendices