First Steps; Installation - Kenmore 253.28459 User Manual

First Steps
This Use & Core Guide provides specific operating
instructions for your model. Use the freezer only as
instructed in this Use & Care Guide. Before starting the
freezer, follow these important first steps.
Installation
° Choose o place that is near o grounded electrical outlet.
Do Not use on extension cord or on adapter plug.
° For the most emcient operation, the freezer should be
located where surrounding temperatures will not exceed
110°F (43°C). Temperatures of 32°F (0°C) and below will
NOT affect freezer operation. Additional compressor
heaters ore not recommended.
° ANow space around the unit for good air circulation.
Leave o 3 inch (75 mm) space on oN sides of the freezer
for adequate circulation.
3" (75 mm)Air Space
3" (75 mm) _]
1"(25 mm)
NOTE
The exterior wails of the freezer may become quite
warm as the compressor works to transfer heat from
the inside. Temperatures as much as 30°F warmer than
room temperature con be expected. For this reason it is
particularly important in hotter climates to allow enough
space for air circulation around your freezer.
Leveling
The freezer must hove oil bottom corners resting firmly on
o solid floor. The floor must be strong enough to support o
fully loaded freezer. NOTE: It is Very Important for your
freezer to be level in order to function properly.
If
the
freezer is not leveled during instoJiotion, the door moy be
misoligned and not close or seal properly, causing cooling,
frost, or moisture problems.
To Level Upright Models:
After discarding crating screws and wood bose, use o
carpenter's level to level the freezer from front-to-back.
Adjust the plastic leveling feet in front, 1/2 bubble higher, so
that the door closes easily when left halfway open.
Plastic
Leveling Feet
[
Crating
Screw
"'. Discard Th r ng Screws
.And (2) Wood Bases
"%
Unpacking and Leveling -- Upright Models
3" (75 mm)
Installation
3" (75 mm)
To Level Chest Models:
If needed, odd metal or wood shims between foot pads
and floor.
Cleaning (Prior to use)
° Wash any removable ports, the freezer interior, ond
exterior with mild detergent ond warm water. Wipe dry.
Do not use harsh cleaners on these surfaces.